2. Install the drive shaft (C) into the gearbox or intermediate drive shaft so that the snap ring (A) fits securely into the groove (B).
3. Install the drive shaft into the hub.
4. Connect the steering knuckle (A) to the front suspension lower arm (B).
5. Tighten the nut (C) to the specified torque and install the cotter pin (D).
6. Install the ball joint pin (C) of the front stabilizer bar (A) into the bracket as shown in the figure. Using the Allen key (B) (5 mm) to hold the ball joint pin, tighten the nut (D).
7. Tighten the new wheel hub mounting nut (A).
Tightening torque - 181 Nm
8. Lock the nut rim (B) as shown in the figure.
9. Install the wheel and tighten the wheel mounting nut.
Tightening torque - 108 Nm
10. Fill the gearbox with working fluid (see chapter "Maintenance and general check and adjustment procedures").
11. Check the front wheel alignment angles (see chapter "Suspension").
The original text of the article is located on the website: HondaBook.ru