Car engine lubrication system Honda Civic 7

Lubrication system — precautions when working with oils
1. Long-term and repeated contact with motor oil removes the natural oil layer from the skin and causes dryness, irritation and dermatitis. In addition, the motor oils used contain potentially dangerous components that...

Engine oil and filter
The procedures for checking the engine oil, changing the oil filter and engine oil are described in the chapter " Maintenance and general check and adjustment procedures ". Location of lubrication system elements (K20A,...

Oil pressure alarm sensor
Examination 1. Disconnect the connector (A) from the oil pressure switch (B). 2. Check the continuity between the positive terminal (C) and the engine (ground). Make sure that there is continuity when the engine is off,...

Checking oil pressure
1. Remove the emergency oil pressure sensor and install a special tool in its place. 2. Start the engine. Stop the engine immediately if the pressure gauge indicates no oil pressure. Repair the lubrication system before...

Oil pan
Removal 1. Remove the engine from the engine compartment. 2. Loosen the bolts and nuts securing the oil pan. 3. Remove the oil pan. Insert a screwdriver or other tool between the oil pan and the cylinder block and...

Oil pump
Removal (D15B, D17A) 1. Drain the engine oil. 2. Remove the timing belt. 3. Remove the oil pan. 4. Remove the oil receiver. 5. Loosen the mounting bolts and remove the oil pump assembly. Removal (K20A, models without...

Oil cooler (K20A, models without balance shaft block)
Replacement 1. Remove the oil filter. 2. Disconnect the bypass hose (A), unscrew the fitting (B) and remove the oil cooler (C). 3. Install the oil cooler with a new sealing ring (D). Tighten the fitting. Tightening...

Oil injectors (K20A, models without balance shaft block)
Examination 1. Remove the oil injectors and check them. a) Check that the pin or drill 1.1 mm passes freely through the hole (A) 1.2mm in oil nozzle. b) Insert a pin or drill 1.1 mm into the oil supply hole 1.2 mm....

Oil Catch Tank (D17A) — Installation
Installation 1. Clean the contact surfaces of the oil separator. 2. Apply a layer of sealant to the contact surface of the oil catch can as shown in the figure. Note: The parts must be installed within the time...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)