Front and rear suspension car Honda Civic 5 and 6

Wheel position
Service information Note: For proper wheel alignment inspection/adjustment, check and adjust the following: Check that the suspension has not been modified, Check tire size and tire pressure. Check wheel and tire...

Kingpin angle
Examination 1. Remove the wheel cap. 2. Raise the car and place a swivel stand under the front wheels and place a panel of the same thickness under the rear wheels/then lower the car. Note: Make sure the machine is...

Inspection/adjustment of the front wheel alignment angle
Inspection 1. Center the steering wheel. Note: Measure the difference in toe-in values with the steering wheel in a strictly straight position. 2. Check the front wheel toe-in angle. Front wheel toe angle. All models...

Inspection/adjustment of rear wheel alignment
Inspection 1. Release the parking brake. Note: If the parking brake is engaged, you may get incorrect measurement data. 2. Check the rear wheel toe-in angle. Rear wheel toe angle If adjustment is required, follow step...

Inspection/adjustment of the rotation angle
1. Jack up the front of the car, place a swivel stand under the front wheels, then lower the car. 2. Jack up the rear of the car. Place panels of the same thickness as the swivel stand under the rear wheels, then lower...

Wheel/hub inspection
Bearing play 1. Raise the machine off the ground and secure it to safety stands in appropriate locations. 2. Remove the wheels, then install the wheel nuts. 3. Attach the pointer sensor as shown. 4. Measure the bearing...

Replacing the front suspension arms
Attention: Replace the self-locking nuts after removal. The vehicle should be lowered to the ground before tightening the bolts and raeitj associated with the rubber mounts and bushings. Note: Remove any dirt, oil or...

Replacing the steering knuckle/hub
Attention. Replace the self-locking nuts after removal. The vehicle should be lowered to the ground before tightening the bolts and nuts associated with the rubber mounts and bushings. Tighten the lock nut to the lower...

Front shock absorber
Removal 1. Remove the front wheels. 2. Remove the flange bolt. 3. Remove the flange bolt and self-locking nut, then remove the shock absorber fork. 4. Remove the shock absorber by removing the two nuts. Disassembly 1....

Rear suspension
Replacing suspension arms Attention. Replace the self-locking nuts after removal. The vehicle should be lowered to the ground before tightening the bolts and nuts associated with the rubber mounts and bushings. Note:...

Rear shock absorber
Removal 1. Remove the rear wheels. 2. Remove the speaker cover (3 doors). For sedan only: Remove the trunk side panel. 3. Remove the two flange nuts. 4. Remove the flange bolt on the shock absorber. 5. Remove the flange...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)