Headlights, exterior and interior lighting of car Honda Civic 8

Description of the external lighting system
Headlight leveling system (with HID) The automatic headlight aiming system consists of an adjustment control unit, body height position sensors, and right and left actuators. The system records the vehicle's position...

Ambient Light Input Test (MICU)
1. Check fuses No.1 (7.5 A), No.12 (10 A), No.13 (10 A), No.15 (7.5 A), No.16 (15 A) [(10 A)], No.17 (15 A) [(10 A)], No.18 (20 A), No.19 (15 A), and No.21 (30 A) [(20 A)] in the under-dash fuse/relay box. If any fuse...

Checking the rain sensor input/automatic light switching
1. Remove cover A from rain/auto light sensor B. 2. Disconnect the 5P connector C from the rain/auto light sensor. 3. Check the terminals of the socket and connector to ensure that they are in good contact. If the...

Headlight adjustment
Warning! The headlights become very hot during operation; do not touch them or adjacent parts immediately after turning them off. Before adjusting the headlights, place the vehicle on a level surface. Make sure your...

Troubleshooting HID Lamp
Attention! When the main light switch is switched on, a high voltage (25,000 V) briefly occurs in the gas-filled high-intensity (HID) lamp holder, which can cause severe electric shock or even death if the following...

Replacement of low and high beam headlights
1. Remove the front bumper. 2. Unscrew the three mounting bolts and slightly remove headlight A. Headlights (low beam): Headlights (high beam): Front parking lights: Front direction indicators: 35 W (with HID) 55 W...

Replacing a HID bulb
Attention! When the main light switch is switched on, a high voltage (25,000 V) briefly occurs in the gas-filled high-intensity (HID) lamp holder, which can cause severe electric shock or even death if the following...

Checking and replacing the combination light switch
1. Remove the steering column covers. 2. Disconnect the 12P connector block A from the central light switch B. 3. Remove the two screws and remove the central light switch by sliding it. 4. Check the connector terminals...

Adjusting the front fog lights
Note: Before adjusting the fog lights, place the vehicle on a level surface. Make sure your tires are properly inflated. The driver's seat must be occupied by the driver or a person of equal weight. Turn the A knob to...

Replacing front fog light bulbs
1. Remove the fender liner. 2. Disconnect the 2-pin connector A of the fog lamp B. 3. Turn the lamp holder C 45° counterclockwise to remove it. 4. Install the bulb in the reverse order of removal.

Checking the backlight switch (R18A)
1. Disconnect the connector A of the background noise sensor. 2. Check the internal circuit of the two-pin reverse gear switch (contact between terminals #1 and #2). Electrical connection should occur when the gear...

Replacing the rear lights and tailgate light
1. Remove cover A and unscrew the two screws from tail light B. 2. Carefully remove the tail light and disconnect the C connectors. 3. Install the parts in the reverse order of removal. Inner rear marker light 1. Remove...

Checking the hazard warning switch
1. Remove the center panel. 2. Remove the two mounting screws, then remove the hazard warning switch from the rear of the panel. 3. Check the continuity of the connection between the terminals in each switch position...

Checking the Turn Signal and Hazard Warning Light Inputs (MICU)
1. Check fuse #10 (7.5A) in the fuse/relay box located under the instrument panel. If either fuse is blown, replace it and proceed to step 3. 2. Disconnect the connectors from the fuse and relay box located under the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)