Car clutch and drive shafts Honda Civic 8

Adjusting the clutch pedal and clutch pedal position sensor
Note: Check the clutch pedal position sensor. Before adjusting the clutch pedal, remove the mat from the driver's side. To compensate for wear, the clutch is self-adjusting. If there is no clearance between the clutch...

Clutch pedal, position sensor, and clutch interlock switch adjustment
Note: Check the clutch pedal position sensor. Before adjusting the clutch pedal, remove the mat from the driver's side. To compensate for wear, the clutch is self-adjusting. If there is no clearance between the master...

Checking the clutch pedal position sensor (R18A)
1. Disconnect the 3P connector from the clutch pedal position sensor. 2. Check the continuity of the connection between the terminals according to the table. If continuity is not as per table data, replace the clutch...

Clutch Replacement (L13A)
1. Check the position of the diaphragm spring petals using the dial indicator A. If the dial indicator readings go beyond the operating value, replace the pressure spring. 2. Install the special tool. 3. To prevent...

Replacing the clutch release bearing
1. Remove the release bearing fork A from the clutch housing B by squeezing the fork mounting spring C with pliers. Remove the release bearing D. 2. Check the bearing by turning it by hand. If turning requires...

Removal the drive shaft
1. Raise the front of the vehicle and place safety stands in appropriate places. 2. Unscrew the nuts and remove the front wheels. 3. Remove the lock washer A, central nut B and unscrew the nut. 4. Drain the transmission...

Checking the drive shaft
1. Check the protective boots of the leading A and driven B joints of the axle shaft C for damage, cracking, grease leaks, or loosening of the mounting clamps D. If any damage is found, replace the boot and its mounting...

Installing the drive shaft
1. Install the new snap ring into the corresponding groove of the drive shaft (left axle shaft). 2. Apply 0.5-1.0 g of consistent grease to the entire spline surface A of the right axle shaft. After applying the grease,...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)