Brake system of the car Honda Civic 7

Bleeding the brake system
Checking the brake fluid level The procedures for checking the brake fluid level are described in the chapter " Maintenance and general check and adjustment procedures ". Bleeding the brake system Note: During bleeding,...

Checking the vacuum hose
1. Disconnect the vacuum hose from the brake booster. Sedan. Hatchback. 2. Start the engine. 3. Check for vacuum in the vacuum hose. If there is no vacuum, replace the vacuum hose with the check valve.

Brake pedal
Checking and adjusting Pedal height 1. Check the height of the brake pedal. a) Turn the brake light switch (A) so that it does not touch the brake pedal. b) Fold back the floor covering on the driver's side. c) Measure...

Master Brake Cylinder (Sedan)
Removal and installation Note: When removing parts, refer to the figure "Removing and installing the brake master cylinder". 1. Remove the brake fluid reservoir cap. 2. Pump out the brake fluid from the reservoir. 3....

Brake Master Cylinder (Hatchback)
Removal and installation the master brake cylinder. 1 - low brake fluid level sensor connector, 2 - bracket, 3 - brake booster, 4 - oil seal (models with double vacuum booster), 5 - oil seal (models with single vacuum...

Vacuum brake booster
Adjusting the rod clearance 1. Install the special tool (A) on the master cylinder. Turn the adjusting nut (D) to set the rod (B) so that it touches piston No.2 (C) of the master cylinder. Note: Make sure that the...

Front brake mechanisms
Examination 1. Preparation: a) Jack up the front of the car and place it on stands. b) Remove the front wheels. 2. Check the axial runout of the brake disc. a) Secure the brake disc by installing washers (A) and...

Rear disc brakes
Examination 1. Check the axial runout of the brake disc. a) Secure the brake disc by installing washers (A) and tightening the wheel nuts (B). b) Install the dial indicator (C) as shown in the figure. c) Rotate the...

Rear drum brakes
Examination 1. Checking the thickness of the brake shoe linings. a) Remove the brake drums. b) Check the thickness of the brake shoe linings. Nominal thickness: sedan - 4.0 mm hatchback - 4.5 mm Minimum thickness of the...

Disassembly and assembly of the working brake cylinder
When removing and installing parts, refer to the assembly drawing "Working brake cylinder". Working brake cylinder. 1 - dust cover, 2 - piston, 3 - cap, 4 - bleed nipple, 5 - piston cuff, 6 - cylinder body, 7 - spring.

Parking brake
Checking the travel of the parking brake lever (sedan) Pull the parking brake lever with a force of 196 N. Count the audible clicks. Lever travel: models with rear disc brakes - 7-8 clicks models with rear drum brakes:...

Anti-lock braking system (ABS)
Description of the diagnostic system The electronic control unit has a fail-safe system that can detect a malfunction in the system. When a malfunction is detected, the electronic control unit switches off the ABS...

Checking the voltage at the terminals of the ABS control unit
1. Using a voltmeter, check the voltage at the terminals of the ABS control unit connector. 2. Compare the measured values with those given in the table "Voltage at the terminals of the ABS control unit". If necessary,...

Removal and installation the pressure modulator and the ABS control unit
Caution: Do not allow the pressure modulator to drop with the ABS control unit. Note: - When removing, follow the assembly drawing "Removing and installing the pressure modulator with the ABS control unit". -...

Checking wheel speed sensors
1. Remove the wheel and inspect the speed sensor and sensor rotor for damage. Replace the sensor and/or sensor rotor if necessary. 2. Check the gap between the wheel speed sensor and the sensor rotor as shown in the...

Removal and installation wheel speed sensors
1. Jack up the car and remove the wheel. 2. Remove the speed sensors, following the figures "Removing and installing the wheel speed sensor". Note: Installation is carried out in the reverse order of removal. Removal...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)