Drive shafts of car Honda Civic 7

Cardan shaft
Examination 1. Perform general checks. a) Shift into neutral. b) Jack up the car; c) By rocking the propeller shaft (B), check that there is no excessive play in the intermediate support bearing (A). d) Make sure that...

Rear gearbox
Checking the oil level and changing it The procedures for checking the level and changing the oil in the rear axle are described in the chapter " Maintenance and general check and adjustment procedures ". Removal 1....

Drive shafts — check
1. Check the inner (A) and outer (B) hinge boot for cracks and damage. Replace the boots (A and B) and boot clamps (C) if necessary. 2. Check that the boot clamps (C) are not loose and that there are no grease leaks....

Front Drive Shafts — Removal
Note: Apply the parking brake before starting work. 1. Jack up the car. 2. Loosen the front wheel mounting nuts (A). 3. Drain the automatic transmission fluid (see chapter " Maintenance and general check and adjustment...

Front Drive Shafts — Disassembly
Inner hinge 1. Remove the retaining ring (B) from the inner joint (A). 2. Remove the boot clamp. To remove the clamp, follow these steps: Caution: Do not damage the case. (Welded clamp) Using wire cutters, cut the...

Front Drive Shafts — Assembly
1. Wind the protective tape (D) onto the drive shaft (A). 2. Install the dynamic damper (C) and boot (B) onto the drive shaft (A). 3. Remove the protective tape. 4. Align the marks (A) on the drive shaft (C) and the...

Front Drive Shafts — Installation
1. Install the snap ring onto the drive shaft or intermediate drive shaft. 2. Install the drive shaft (C) into the gearbox or intermediate drive shaft so that the snap ring (A) fits securely into the groove (B). 3....

Front Intermediate Drive Shaft — Removal
1. Remove the right drive shaft (see section " Front drive shafts "). 2. Loosen the bolts. 3. Remove the intermediate drive shaft. Note: Be careful when removing the intermediate drive shaft, the sharp splines on the...

Front Intermediate Drive Shaft — Disassembly
1. Remove the snap ring (A), oil seal (B) and outer snap ring (C). 2. Using a mandrel and press, press the drive shaft out of the bearing. Note: When pressing out, do not damage the ring on the drive shaft. 1 - bracket,...

Front Intermediate Drive Shaft — Assembly
1. Using special tools, press the bearing into the bracket. 2. Install the inner snap ring. 3. Using a press, press the intermediate shaft into the bearing. 4. Install the outer snap ring. 5. Apply grease to the oil...

Front Intermediate Drive Shaft — Installation
1. Install the intermediate drive shaft. Intermediate drive shaft. 1 - intermediate drive shaft, 2 - thrust ring, 3 - outer retaining ring, 4 - bolt, 5 - oil seal, 6 - retaining ring, 7 - bracket, 8 - bearing, 9 - inner...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)