Overhaul of car engines Honda Civic 7

General Repair Procedures — Cylinder Head
Disassembly 1. Remove the camshafts. 2. Remove the VTEC rocker arm assembly. 3. Remove the tappets. Note: Arrange the tappets in the order they are installed. 4. Remove the valves. a) Using a suitable tool, compress the...

Cylinder Block — Disassembly, Check, Cleaning and Repair
Disassembly, inspection, cleaning and repair 1. Remove the oil pan. 2. Check the axial clearance of the connecting rod bearing. - Using a feeler gauge, measure the axial clearance of the connecting rod bearing. Axial...

Cylinder Block — Disassembly of the Piston-Connecting Rod Unit (D15B, D17A)
1. Check the fit of the piston-piston pin joint. If the connecting rod does not drop under its own weight, replace the piston, connecting rod and/or piston pin. 2. Replace the entire assembly if necessary. a) Using a...

Cylinder block — disassembly of the piston-connecting rod unit (K20A)
1. Apply a coat of engine oil to the retaining ring (A) and rotate it in the groove so that the gap in the ring end aligns with the groove (B) in the piston. 2. Remove both retaining rings. 3. Heat the piston-connecting...

Cylinder Block — Checking the Condition of the Piston and Connecting Rod
1. Clean the piston. a) Use a scraper to remove carbon deposits and other carbon deposits from the piston crown. b) Clean the piston grooves from deposits using a part of the broken ring. c) Using solvent and a soft...

Cylinder Block — Crankshaft Check and Repair
1. Checking the crankshaft runout, a) Place the crankshaft on the prisms. b) Using a dial indicator, check the runout of the crankshaft on the central main journal. Nominal runout: K20A (models with type 3 rocker block)...

Cylinder Block — Piston-Connecting Rod Assembly (D15B, D17A)
1. Assemble the connecting rod and piston group, a) Install the piston and connecting rod so that the "IN" mark (B) on the piston is on the same side as the oil passage (A) on the connecting rod. b) Apply a small amount...

Cylinder block — piston-connecting rod assembly (K20A)
1. Install the retaining ring (A) into the piston. 2. Install the piston and connecting rod so that the marks are located as shown in the figure. 3. Heat the piston to 70° and install the piston pin. 4. Install the...

Checking the balance mechanism (K20A models with a balance shaft block)
1. Check the axial clearance of the balance shafts. Use a dial indicator to measure the axial clearance while moving the balance shafts back and forth. Axial clearance of balance shafts: nominal - 0.070 -0.135 mm...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)