Car suspension and wheels Honda Civic 8

Wheel alignment angles (L13A/R18A)
The suspension allows for front and rear wheel alignment adjustments. However, each of these adjustments is interrelated with the other. For example, when you adjust the camber, the toe-in changes. Therefore, you need...

Wheel alignment angles (N22A)
The suspension allows for adjustment of the front and rear wheel alignment. However, each of these adjustments is interconnected with the other. For example, when you adjust the camber, the wheel alignment changes....

Checking the wheel rim runout
Note: To measure front wheel runout, slowly rotate the wheel by hand from the opposite side. 1. Raise the vehicle and place safety supports in appropriate places. 2. Make sure there are no dents or deformations on the...

Checking the wheel bearing play
1. Raise the vehicle and place safety supports in appropriate places. 2. Remove the wheels. 3. Install suitable flat washers A and wheel nuts. Tighten the nuts to the specified torque to securely fasten the brake disc...

Removal the front ball joint
Note: Always use a ball joint removal tool to disassemble the ball joint. When disassembling the joint, do not hit the joint housing or other parts. 1. Screw nut A onto thread B of ball joint pin. Make sure that the nut...

Replacing the front hinge cover
1. Remove the cover retainer and cover. 2. Fill the inside of the new boot and lubricate the seat belt A with consistent grease. Avoid getting grease on the matte surfaces of the boot and lower hinge B. 3. Remove the...

Removal and installation the front anti-roll bar link
1. Raise the front of the vehicle and place safety supports in appropriate places. 2. Remove the front wheels. 3. Remove flange nut A and self-locking nut B while holding the corresponding pins of the C joints using the...

Replacing the front shock absorber spring
Note: When compressing the suspension spring, use a commercially available spring compressor (Branick MST-580A or Model 7200, or equivalent). Follow the manufacturer's recommendations. Removal 1. Raise the front of the...

Removal and installation the front lower link
Removal and installation the lower arm 1. Raise the front of the vehicle and place safety stands in appropriate places. 2. Remove the front wheels. 3. For HID model: Remove the front headlight leveling sensor. 4. Remove...

Replacing the front anti-roll bar
1. Raise the front of the vehicle and place safety supports in appropriate places. 2. Remove the front wheels. 3. Remove the lower engine cover. 4. Remove the lower arm. 5. Disconnect both stabilizer links from the...

Replacing the rear suspension
Dismantling 1. Raise the rear of the vehicle and place safety stands in appropriate places. 2. Remove the rear wheel. 3. For HID model: Remove the rear headlight leveling sensor. 4. Remove the rear spring support lower...

Replacing the rear spring
Removal 1. Raise the rear of the vehicle and place safety stands in appropriate places. 2. Remove the rear wheel. 3. For HID model: Remove the rear headlight leveling sensor. 4. Remove the rear spring support lower...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)