Manual transmission specifications 1st gear Axial clearance - 0.03-0.18 mm Thickness of adjusting washers - 1.89-1.92 mm Gears 2nd, 3rd, and 4th gears Axial clearance - 0.05-0.18 mm Thickness of adjusting rings 28.01-28.04mm 28.04-28.07mm 28.07-28.10mm...
General information about manual transmission The vehicles covered in this manual are equipped with 4- and 5-speed manual transmissions or a 3-speed automatic transmission. Information about manual transmissions is included in this Part of Chapter 7. The...
Replacement of oil seals 1. Oil leaks occur mainly due to wear of the drive seals and / or speedometer drive seals. Replacing these seals is relatively easy as the repair can be done without removing the box from the vehicle. 2. Drive shaft...
Gearbox support — control and replacement 1. Insert a large screwdriver or pry bar between the support and the box and lift it up. 2. The box should not move more than 13-19 mm from the support. If this distance is greater, replace the support. 3. To replace...
Switch lever — removal and installation 1. Raise the vehicle and place it on stands. 2. From the bottom of the car, unscrew the through bolt and nut and disconnect the lever rod from the control rod. 3. Remove washers, bushings, spacers and rubber rings. Pic....
Gearbox — removal and installation Withdrawal 1. Disconnect the negative cable from the battery. 2. Raise the vehicle and place it on stands. 3. Drain the oil from the box ( see chapter 1 ). 4. Remove the linkage from the box. Pic. 5.4a Gearbox linkage...
Gearbox repair Disassembly - five-speed gearbox 1. Remove the box ( see Part 5 ). Drain the oil if you haven't already. Rinse the box. 2. Remove the bolts and remove the rear cover from the crankcase (see fig. 6.2). Pic. 6.2...