Location of steering parts Pointer Power steering. Note: if an intact airbag was removed from a vehicle destined for scrapping» or if a defect or damage is discovered during transport, storage or servicing, it must be destroyed. Remove the airbag...
Check and adjustment Steering operation Place the front wheels in position "directly" and measure the distance the steering wheel can be turned with the front wheels stationary. Backlash: (0-10) mm If the play exceeds the limit value,...
Steering rack adjustment Note: Adjust the steering rack with the wheels in a strictly straight position. Left hand drive: 1. Loosen the locknut of the steering rack clamp screw with a special tool, then loosen the steering rack clamp screw. 2....
Fluid replacement Check the fill barrel regularly and add liquid as needed. Caution: Use only genuine Genuine Honda Power Steering Fluid-V. Using other fluids will damage the system. System capacity: 0.85 liters when disassembled Filling...
Inspection and adjustment Checking pump pressure Check the fluid pressure as follows to determine if there is a problem with the pump or steering rack. Note: First check the power steering fluid level and pump belt tension. Attention. Disconnect...
Steering wheel Removal Cars with SRS SRS parts are located in this area, learn SRS parts locations, safety precautions and work procedures for vehicles with SRS (section 24), before performing repairs or maintenance. Note: Before...
Steering column Removal/Installation The location of the SRS parts is given in this section. Review parts locations, safety precautions, and work procedures in the SRS before performing repairs or maintenance. Note: Before removing the...
Power steering pipes and hoses Inspecting Fluid Leaks Note: The picture shows a left-hand drive car, a right-hand drive car is symmetrical. Hoses and tubes: Inspect hoses for damage, leaks, kinks, or kinks. Inspect fluid lines for damage, rust, or...
Power steering pump Removal/Installation Note: Before disconnecting the hoses from the pump, place a suitable tray under the vehicle. 1. Drain the fluid from the power steering fill barrel. 2. Remove the belt by loosening the pump mounting...
Rack and pinion mechanism Removal Note: Wash off dirt and oil from the valve body, lines and gearbox using solvent and a brush. Dry with compressed air. 1. Drain the power steering fluid. 2. Raise the front of the car and secure it to the safety...