Vehicle electrical equipment and instruments Honda Civic 8

Checking the door lock cylinder switch
1. Remove the driver's door panel. 2. Disconnect the 10-terminal block (10P) connector from the lock cylinder switch. 3. Check the connection between the terminals. There should be a connection between terminals #8 [7]...

Checking the door lock button switch
1. Remove the passenger door panel or rear door panel. 2. Disconnect connector A from actuator B. 3. Check the connection between the terminals. There should be a connection between terminals #8 [7] and #10 [5] when the...

Checking and replacing the cigarette lighter
1. Remove the rear center console. 2. Disconnect the 2P connector A from the cigarette lighter B. 3. Check the connector terminals to ensure they are in good contact. If the terminals are bent, loose or corroded, repair...

Headlamp Washer Control Unit Input Test
1. Remove the lower part of the control panel. 2. Disconnect 6P connector A from headlight washer control unit B. 3. Check the terminals of the socket and connector to ensure that they are in good contact. If the...

Windshield Wiper and Washer Input Test (MICU)
1. Before troubleshooting the wiper/washer system, check fuses #0 (7.5 A) and #38 (30 A) in the under-dash fuse/relay box. 2. Disconnect the connectors from the fuse and relay box located under the control panel. Note:...

Checking and replacing the windshield wiper/washer switch
1. Remove the steering column covers. 2. Disconnect the 8P connector A from the wiper/washer switch B. 3. Remove the two screws and wiper/washer switch. 4. Check the connector terminals to ensure that they are in good...

Windshield Wiper Motor Replacement
1. Open the hood. Remove the caps, nuts A and wiper arms B. 2. Remove shields B. 3. Remove the bolts and the top of the control panel A. 4. Disconnect the 5P connector from the wiper motor B, then remove the seven bolts...

Electric windows
Auto-reverse operation The system consists of a main window switch and a window lift actuator on the driver's and front passenger's sides. The driver's window lift drive includes a pulsator that generates pulses during...

Setting up the window lift control unit
Note: If any of the above occurs, the driver's window regulator will need to be re-adjusted. Replacement or repair of the window regulator. Replacement or repair of the window lift motor. Replacement or repair of glass...

Checking the driver's side window lift motor
Checking the electric drive 1. Remove the door panel. 2. Disconnect the A 6P connector block from the windshield wiper drive. 3. Check the operation of the drive in each direction by connecting the battery power and...

Checking the front passenger side window switch
Checking the electric drive 1. Remove the door panel. 2. Disconnect the A 6P connector block from the windshield wiper drive. 3. Check the operation of the drive in each direction by connecting the battery power and...

Checking the rear window lift drive
1. Remove the door panel. 2. Disconnect the A 6P connector block from the windshield wiper drive. 3. Check the operation of the drive by connecting the battery power and ground according to the table. When the drive...

Checking the Input Signal of the Front Passenger Window Switch
Note: The power window control unit is built into the passenger side power window switch. 1. Remove the front passenger side window switch A. 2. Disconnect the 14P connector B from the front passenger side window...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)