Steering wheel play check 1. Set the front wheels to straight ahead. 2. Check the steering wheel play when turning left and right before turning the wheels. If the play is within acceptable limits, the steering gear and tie rods are in good...
Power steering check Note. This check must be carried out using the original tires and wheels and with the correct tire pressure. 1. Start the engine and let it idle. 2. Connect a commercially available spring scale to the steering wheel....
Removal/installation of a cover of a steering column Note. Do not scratch or damage the steering column covers. Do not use tools to lift shrouds. 1. Release the steering wheel adjustment lever A and set the steering column to its highest position, moving it away from you...
Removal and installation of a steering column Note. Try not to move bracket A, located in front of the steering column, from its normal position. If the bracket is accidentally dislodged, replace the steering column assembly. Withdrawal 1. Make sure the ignition is...
Checking the steering column and adjustment lever Check that the ball bearing A of the steering column and the bearings of the steering shaft pivots move normally and do not have excessive play. If there is too much play in any of the bearings, replace the steering...
Removing the steering wheel 1. Make sure the ignition is off, then disconnect the negative cable from the battery. 2. Align the front wheels, then remove the driver's airbag from the steering wheel. 3. Disconnect the optional cable connector...
Steering wheel installation 1. Before installing the steering wheel, make sure the front wheels are in the straight-ahead position, and then set the rotary contactor A to the middle position. To do this, first turn the rotary contactor clockwise...
Replacement of a protective cover of a steering shaft 1. Remove the cover from the tie rod end and remove the old grease from the ball pin. 2. Fill the bottom cavity of the ball pin with fresh multipurpose grease. 3. Fill the inside of the new boot B with fresh...