Vehicle operating manual Honda Civic 7

Location of identification numbers
The location of the vehicle and component identification numbers is shown in the figure. Models with engines D15, D17 Models with K20A engine.

Technical characteristics of engines installed on Honda Civic/Civic Ferio
Note: The given power and torque values are approximate and may vary depending on the specific modification and year of manufacture, but in most cases the error does not exceed ±5%. Table. Engine characteristics Engine...

Abbreviations and symbols
Abbreviations A/C - air conditioner ABS — anti-lock braking system AT (A/T) — automatic transmission CVT — continuously variable transmission DPS — all-wheel drive connection system ECU — Electronic Control Unit EGR -...

General repair instructions
1. Use fender covers, seat covers and floor mats to protect your vehicle from dirt and damage. 2. When disassembling, arrange the parts in the proper order to facilitate subsequent assembly. 3. Observe the following...

Garage jack and lift paw mounting points
Garage jack and lift paw mounting points Lift paw installation points . Installation points for the trolley jack.

Instrument cluster of different types of cars
CAUTION: When working inside a vehicle equipped with an airbag and seat belt pretensioner system (SRS system), be especially careful not to damage the SRS control unit. To avoid accidental deployment of the airbags or...

Odometer, trip meter and tachometer
Odometer and trip meter. a) The odometer shows the total mileage of the vehicle. b) Odometers show the distance the vehicle has traveled since the last time the odometer was reset to zero. c) The "ODO/TRIP" button is...

Fuel and coolant temperature gauge
Coolant temperature gauge The gauge shows the engine coolant temperature when the ignition switch is in the "ON" position. If the pointer of the indicator entered the red zone of the "H" scale while the engine was...

Instrument cluster indicators
1. Parking brake system status and low brake fluid level indicator. a) The indicator lights up if: parking brake engaged; low brake fluid level; the electrical circuit of the indicator is faulty. b) If the indicator...

Door window lifters
Window lifters On models with electric door window lifts, the position of the door windows is adjusted by pressing the corresponding switch. In this case, the key in the ignition switch must be set to position "II"....

Light signaling in the car
1. Turning on the side lights, headlights, instrument cluster and license plate lighting. Note: The headlight and turn signal switch operates regardless of the position of the key in the ignition switch. a) When you...

Hood and trunk lid
1. To open the hood, you must perform the following procedures: a) Pull the hood lock release lever as shown in the figure. b) Raise the hood slightly and pull the hood lock lever up. c) Raise the hood and secure it to...

Fuel filler neck hatch
To open the fuel filler flap, press the fuel filler flap lock drive lever. Unscrew the fuel filler cap and install it in the holder located on the hatch.

Windscreen wiper and washer control
The windshield wiper and washer control switch operates when the ignition key is in the "N" position. 1. To turn the cleaner on and off, move the switch to one of the positions: "OFF" - complete stop; "INT" -...

Adjusting the position of the steering wheel
To adjust the vertical position of the steering wheel, pull the locking lever down. Further adjustment is made by moving the steering wheel vertically, while the steering wheel tends to take the highest position, since...

Mirror control
Mirror adjustment is performed from the mirror control panel. The ignition key must be in position "II". The selection of control of the right or left mirror is carried out by setting the switch (1) to the appropriate...

Seats — adjustment
1. Adjusting the longitudinal position of the front seats. To adjust the longitudinal position of the seats, move the lever up and move the seat to the desired position. After adjustment, return the lever to its...

Seat belts
To protect you and your passengers in the event of a traffic accident, it is recommended that all people in the vehicle wear seat belts. Attention: Do not wear the shoulder portion of the belt so that it passes under...

Precautions when operating vehicles equipped with the SRS system
The SRS airbags are designed only as a supplement to the primary safety belt system on the driver and front passenger sides. Sedan, hatchback (five-door models). Sedan, hatchback (five-door models). The driver and front...

Luke — control
The sunroof can be operated when the ignition key is in the "N" position. The sunroof can be in two different open positions: slid and angled open. Opening and closing the hatch Warning: When closing and opening the...

Heater and air conditioner control
The operation of the air conditioner and heater is controlled from the control panel. 1. To turn on the heater, move the heater fan speed switch (3) from the "OFF" position to any other position. To turn on the air...

Rear window defroster
If the rear window fogs up, press the rear window defroster switch. In this case, the key in the ignition switch must be set to the "ON" position. The heater's operation is accompanied by the indicator on the switch...

Radio tape recorder — main points of operation
Key points of operation Radio The quality of radio signal reception may vary significantly while the vehicle is moving due to terrain features, weather conditions and proximity to sources of electromagnetic radiation....

Anti-lock braking system (ABS)
Caution: Use tires of the same size, construction and load capacity as the original vehicle tires, as using a different type of tire may interfere with the proper operation of the anti-lock braking system (ABS). 1....

Emergency Braking System (BA)
The system recognises an emergency braking situation and automatically increases the brake pressure, thereby ensuring maximum braking force. The system provides emergency braking when the driver presses the brake pedal...

Driving a car with automatic transmission
To control the automatic transmission, a selector is installed on the central console. The selector is connected to the valve block by a cable, and with its help you can set the range of gears used. To prevent...

Driving a car with a CVT
To control the variator, a selector is installed on the central console. The selector is connected to the variator by a cable and can be used to set the variator operating mode. To prevent damage to the variator when...

Driving a car with a manual transmission
The gear layout diagram is shown in the figure. The diagram is also depicted on the lever handle. Always fully depress the clutch pedal before changing gears. Sedan. Hatchback (three-door models). Attention: Do not rest...

Features of the transmission of 4WD models
Caution: To avoid damage to transmission components, partial loading of 4WD models is prohibited (by raising only one of the vehicle's axles). Models with 4WD have automatically connected all-wheel drive. The rear axle...

Tips for driving in different conditions
General recommendations Attention: Before driving, make sure that the parking brake is fully released and the corresponding indicator is off. Do not keep your foot on the brake pedal while driving. This can lead to...

Towing a car
Attention: towing of cars with automatic transmission is permitted at a speed of no more than 55 km/h for a distance of no more than 80 km. If towing is necessary over a longer distance, it must be done by the full...

Starting the engine
Ignition switch There are four fixed positions of the key in the ignition switch: 0: In this position, the key can be inserted or removed from the ignition switch. When the key is removed, the steering wheel is locked....

Engine malfunctions while driving
Engine stops while driving 1. Reduce speed gradually. Move the car to a safe place. 2. Turn on the hazard warning lights. 3. Try to start the engine. Note: When the engine is not running, the brake and power steering...

Spare tire, jack and tools
The spare tire, jack and tools are stored in the luggage compartment as shown in the figure. Sedan. 1 - tools, 2 - spare wheel, 3 - jack. Hatchback (five-door models). 1 - tools, 2 - jack, 3 - spare wheel. Hatchback...

Jacking up a car
1. Place the vehicle on a level and firm surface. 2. Turn off the engine, apply the parking brake and block the wheel diagonally opposite the one to be replaced. 3. Place the jack only in the places specially designated...

Wheel replacement
1. If you need to change a tire on the road, gradually reduce speed and move the car to a safe place. 2. Stop the vehicle on a level place with firm ground. 3. Stop the engine and turn on the hazard warning lights. 4....

Recommendations for choosing tires
When choosing tires, pay attention to the markings. The geometric dimensions, load capacity and maximum speed must strictly comply with the manufacturer's recommendations. The landing diameter of the selected tire must...

Checking tire pressure and condition
1. Check your tires regularly for damage. Check your tire pressure every two weeks or at least once a month. Don't forget to check the pressure in your spare tire. The Honda recommended tire pressure for your vehicle's...

Tire replacement
1. When replacing tires, use only tires of the same size and design as those originally installed, and with the same or greater load capacity. Using a tire of any other size or type may seriously affect handling,...

Features of using aluminum wheels
Caution: To avoid damaging the protective varnish layer, do not allow tire shop workers to clean the outer surface of the rim with a wire brush or remove adhesive balancing weights with a screwdriver when replacing...

Replacement of wheel disks
1. Due attention should be paid to replacing wheel rims. Make sure that rims with the same load capacity, diameter, rim width and offset are installed. 2. Incorrect selection of wheels and tires can adversely affect...

Brake pad wear indicators
Disc brake pads are equipped with wear indicators in such a way that when driving, when the thickness of the pads is minimal, the wear indicator touches the brake disc and the brakes make an unpleasant sound ("squeal").

Catalytic converter and exhaust system
A catalytic converter is a device that reduces the toxicity of exhaust gases. When operating a vehicle equipped with a catalytic converter, observe the following precautions: Table. Correspondence of tire sizes with...

Checking and replacing fuses
If the headlights or other electrical components do not work, check the fuses. If any of the elements are burnt out, they must be replaced. Note: To remove and install type "A" fuses, use a special "tweezers" type...

Replacing lamps
When replacing a bulb, make sure the ignition and all lights are off. Use only bulbs with the rated power specified in the table. Table. Fuses in the engine compartment block. Fuse Fuse chain Denomination 1 Air...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)