Exterior (external body elements) of the car Honda Civic 6

Bodywork — General information and precautions
The body of the vehicles considered in this Manual has a universal design, the supporting element of which is the floor panel, equipped with front and rear side members and forming a semblance of a frame, to which, in...

Car body and underbody components care
It should be remembered that the main factor determining the resale value of a used car is the condition of its body. Body panel maintenance procedures are extremely simple, but must be performed on a regular basis....

Caring for Vinyl Trim Elements
Do not use detergents, caustic soda, or petroleum-based cleaners when cleaning vinyl panels. A warm solution of soap and water is perfect for this purpose. Stubborn dirt can be easily removed with a soft brush (with...

Caring for upholstery and carpeting
Every three months, remove the carpets and mats and clean the interior trim panels. If necessary, this procedure can be performed more often. To remove debris, as well as to clean the carpets and mats, you can use a...

Repair of minor damage to body panels
See accompanying series of illustrations. These photographs illustrate the method of restoring simple dents. They cannot be used as a sole guide to body repair of cars of this model. 1. If you cannot access the back of...

Repair of seriously damaged body panels
Such repairs are usually performed using welding equipment and must be carried out in a car service workshop. In case of extensive damage, the first thing to check is whether there has been any displacement or...

Maintenance of car hinges and locks
Every 5,000 km (3,000 miles) or every three months, the hinges and assemblies of the door, hood and trunk lid latches should be lubricated with a few drops of liquid oil or a special lock lubricant. The strikers of the...

Removal, installation and adjustment of the hood position
Removal and installation Note: The hood panel is quite heavy, so you may want to have an assistant help you. 1. Cover the fenders with special pads or just old blankets to protect them from damage during the process of...

Removal and installation the hood lock latch and its drive cable
Warning! The vehicles covered in this Manual are equipped with airbags (SRS). When performing any work near the impact sensors, steering column or instrument panel, turn off the SRS (see the electrical connection...

Removal and installation front and rear bumper assemblies
Front bumper 1. Set the parking brake, jack up the vehicle and place it on supports. 2. Disconnect the negative cable from the battery. Warning! If the car stereo system is equipped with a security code, make sure you...

Removal and installation front fenders
1. Loosen the nuts of the corresponding front wheel. Jack up the front of the car and place it on supports. Remove the wheel. 2. Remove the front bumper cover (see Removal and installation front and rear bumper...

Removal and installation rear view mirrors
Exterior mirrors 1. Remove the door interior trim panel and water shield (see Removal and installation interior door trim ). 2. Using a screwdriver, remove the triangular decorative panel of the inner trim of the mirror...

Control body dimensions
Acura Integra, 1995, 2-door Hatchback. Body openings Acura Integra, 1995, 2-door Hatchback. Bottom Acura Integra, 2000, Sedan. Body openings Acura Integra, 2000, Sedan. Bottom Honda Civic, 1999, 2-door hatchback. Body...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)