Automatic transmission of the car Honda Civic 7
.
Automatic transmission (SLXA (2WD) and SSTA (4WD)) — general information
Power from the engine is transmitted to the input shaft of the gearbox via a torque converter. Gear shifting is accomplished by engaging a specific combination of controls, which changes the output shaft speed....
Power from the engine is transmitted to the input shaft of the gearbox via a torque converter. Gear shifting is accomplished by engaging a specific combination of controls, which changes the output shaft speed....
Automatic transmission diagnostics
Description of the diagnostic system The electronic control unit has a failure protection system that can detect a malfunction in the system. When the ignition key is turned to the "ON" position, the automatic...
Description of the diagnostic system The electronic control unit has a failure protection system that can detect a malfunction in the system. When the ignition key is turned to the "ON" position, the automatic...
Checking mechanical systems of the gearbox
Test on a fully braked car (Stall test) 1. Preparation: a) Apply the parking brake and place chocks under the wheels. b) Check the following parameters: engine coolant level; engine oil level; automatic transmission...
Test on a fully braked car (Stall test) 1. Preparation: a) Apply the parking brake and place chocks under the wheels. b) Check the following parameters: engine coolant level; engine oil level; automatic transmission...
Overdrive Switch and Shift Lock Solenoid (Hatchback)
Examination 1. Remove the center console (see chapter " Body "). 2. Disconnect the selector lock solenoid valve connector. Sedan. Hatchback. 3. (Sedan) Connect terminal "1" to the positive terminal of the battery,...
Examination 1. Remove the center console (see chapter " Body "). 2. Disconnect the selector lock solenoid valve connector. Sedan. Hatchback. 3. (Sedan) Connect terminal "1" to the positive terminal of the battery,...
Position sensor
Examination 1. Remove the center console and selector trim (see the "Body" chapter). 2. Disconnect the connector shown in the figure. 3. Set the selector to position "P" and make sure there is conductivity between...
Examination 1. Remove the center console and selector trim (see the "Body" chapter). 2. Disconnect the connector shown in the figure. 3. Set the selector to position "P" and make sure there is conductivity between...
Start inhibit switch
Examination 1. Remove the start inhibit switch cover and disconnect the connector from the start inhibit switch. 2. Check for continuity between the terminals indicated in the table below, with the selector in the...
Examination 1. Remove the start inhibit switch cover and disconnect the connector from the start inhibit switch. 2. Check for continuity between the terminals indicated in the table below, with the selector in the...
Torque Converter Lockup Solenoid Valve
Examination 1. Disconnect the torque converter lockup solenoid valve connector. 2. Check the resistance between the terminals of the solenoid valve. Resistance - 12 - 25 Ohm 3. Connect terminal "2" of the...
Examination 1. Disconnect the torque converter lockup solenoid valve connector. 2. Check the resistance between the terminals of the solenoid valve. Resistance - 12 - 25 Ohm 3. Connect terminal "2" of the...
Gearshift Solenoid valves
Examination 1. Disconnect the transmission shift solenoid connector. 2. Check the resistance between terminal "1" (gear shift solenoid valve "A") of the connector and ground and between terminal "2" (gear shift solenoid...
Examination 1. Disconnect the transmission shift solenoid connector. 2. Check the resistance between terminal "1" (gear shift solenoid valve "A") of the connector and ground and between terminal "2" (gear shift solenoid...
Pressure control solenoid valves
Examination 1. Disconnect the pressure control solenoid valve connector ("A" or "B"). 2. Check the resistance between the connector terminals of each solenoid valve. Resistance - ≈5 Ohm 3. Apply voltage to the terminals...
Examination 1. Disconnect the pressure control solenoid valve connector ("A" or "B"). 2. Check the resistance between the connector terminals of each solenoid valve. Resistance - ≈5 Ohm 3. Apply voltage to the terminals...
Input shaft speed sensor
Replacement 1. Disconnect the transmission input shaft speed sensor connector. 2. Loosen the bolts and remove the sensor (A). 3. Install a new O-ring (B) onto the new transmission input shaft speed sensor. 4. Install...
Replacement 1. Disconnect the transmission input shaft speed sensor connector. 2. Loosen the bolts and remove the sensor (A). 3. Install a new O-ring (B) onto the new transmission input shaft speed sensor. 4. Install...
Output shaft speed sensor
Replacement 1. Disconnect the transmission output shaft speed sensor connector. 2. Loosen the bolts and remove the sensor (A). 3. Install a new O-ring (B) onto the new transmission output shaft speed sensor. 4. Install...
Replacement 1. Disconnect the transmission output shaft speed sensor connector. 2. Loosen the bolts and remove the sensor (A). 3. Install a new O-ring (B) onto the new transmission output shaft speed sensor. 4. Install...
Selector — removal, installation
Removal (sedan) 1. Set the selector to the "N" position. 2. Remove the center console (see chapter " Body "). 3. Loosen the nut and disconnect the gearbox control cable. 4. Turn the protruding part (A) of the holder 90°...
Removal (sedan) 1. Set the selector to the "N" position. 2. Remove the center console (see chapter " Body "). 3. Loosen the nut and disconnect the gearbox control cable. 4. Turn the protruding part (A) of the holder 90°...
Gearbox control cable
Adjustment (sedan) 1. Set the selector to the "N" position. 2. Remove the center console (see chapter " Body "). 3. Loosen the nut and disconnect the gearbox control cable. 4. Turn the protruding part of the holder (A)...
Adjustment (sedan) 1. Set the selector to the "N" position. 2. Remove the center console (see chapter " Body "). 3. Loosen the nut and disconnect the gearbox control cable. 4. Turn the protruding part of the holder (A)...
Gearbox SLXA (2WD)
Removal 1. Jack up the car and remove the front wheels and mudguards. 2. Unscrew the drain plug (A) and drain the working fluid. 3. Remove the gasket (B) from the drain plug. 4. Disconnect the cable from the negative...
Removal 1. Jack up the car and remove the front wheels and mudguards. 2. Unscrew the drain plug (A) and drain the working fluid. 3. Remove the gasket (B) from the drain plug. 4. Disconnect the cable from the negative...
SSTA Transmission (4WD)
Removal 1. Jack up the car and remove the front wheels and mudguards. 2. Unscrew the drain plug (A) and drain the working fluid. 3. Remove the gasket (B) from the drain plug. 4. Disconnect the cable from the negative...
Removal 1. Jack up the car and remove the front wheels and mudguards. 2. Unscrew the drain plug (A) and drain the working fluid. 3. Remove the gasket (B) from the drain plug. 4. Disconnect the cable from the negative...
Transfer case
Checking the play 1. Set the selector to the "N" position. 2. Apply marks (C) to the flanges of the transfer case (A) and the propeller shaft (B). 3. Loosen the bolts and disconnect the propeller shaft from the transfer...
Checking the play 1. Set the selector to the "N" position. 2. Apply marks (C) to the flanges of the transfer case (A) and the propeller shaft (B). 3. Loosen the bolts and disconnect the propeller shaft from the transfer...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Technical data
- Governing bodies
- Driving and maintenance
- Power unit
- Gasoline engines (L13A)
- Gasoline engines (R18A)
- Diesel engines (N22A)
- Cooling and lubrication (L13A)
- Cooling and lubrication (R18A)
- Cooling and lubrication (N22A)
- Injection system (gasoline)
- Injection system (diesel)
- Toxicity reduction system
- Troubleshooting
- Transmission
- Clutch and drive shafts
- Mechanical gearbox
- Chassis and running gear
- Suspension and wheels
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Power devices
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- Engines D15B and D17A
- K20A Engines
- Overhaul engine
- Cooling system
- Lubrication system
- Fuel injection system
- Toxicity reduction system
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Manual air conditioner
- Automatic air conditioner
- Security system
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Windscreen wipers
- Audio system
- Electrical diagrams
- General information
- Introduction to guide
- User manual
- Maintenance
- Power unit
- Engine in car (Civic)
- Engine in car (Integra)
- Engine overhaul
- Cooling and heating
- Power and exhaust systems
- Engine electrical equipment
- Engine management systems
- Transmission
- Manual gearbox
- Automatic transmission (AT/CVT)
- Clutch and drive shafts
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
- Power unit
- SOHC engines
- DOHC engines
- Engine overhaul
- Cooling and lubrication system
- Intake and exhaust system
- Fuel injection system (SOHC)
- Fuel injection system (DOHC)
- Carburetor
- Transmission
- Clutch
- Manual gearbox S4C
- Manual gearbox S40
- Automatic gearbox
- Drive shafts
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Body elements
- Heater and air conditioner
- Electrical equipment
- Power devices
- Equipment and instruments
- Electrical circuits
- General information
- Maintenance
- Power unit
- Engine in a car
- Engine overhaul
- Cooling system
- Power and exhaust system
- Engine electrical equipment
- Emission control system
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch and drive shafts
- Four-wheel drive
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Body elements
- Electrical equipment
- Equipment and devices
- Electrical circuits