Car steering Honda Civic 3 and 4

Steering wheel — removal and installation
1. Disconnect the cable from the negative battery terminal. 2. Use a screwdriver to pry up the horn cover emblem. 3. Mark the relative position of the wheel hub and steering shaft and unscrew the mounting nut. Fig. 24.3...

Tie Rod Ends — Removal and Installation
Removal 1. Loosen the wheel nuts. Raise the front of the car, place it on stands and remove the wheels. 2. Holding the tip with a wrench, release the lock nut, unscrew it to a distance sufficient to apply a paint mark...

Steering gear dust boots — replacement
1. Loosen the wheel nuts, lift the front of the car and place it on stands. Remove the wheels. Fig. 26.3 Each steering gear boot is secured with two clamps 2. Remove the tie rod ends and lock nuts ( see section 25 ). 3....

Steering gear — removal and installation
Note: The disassembly algorithm applies to both mechanical steering and power steering. If your car is not equipped with power steering, just ignore the items related to power steering (GUR). Removal 1. Raise the front...

Power steering pump — removal and installation
1. Depending on the model, the power steering pump can be removed either from the top or bottom of the vehicle. In the latter case, lift the vehicle onto stands. 2. Disconnect the hoses from the pump. Remember or mark...

Power steering — bleeding the system
1. Set the wheels to the straight-ahead position, check the fluid level ( see Chapter 1 ). If necessary, top up to the "Cold" mark (models produced between 1984 and 1987) on the dipstick or to the lower mark of the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)