Car maintenance Honda Civic 7

Maintenance — Service Intervals
If you primarily operate your vehicle under one or more of the following special conditions, more frequent maintenance may be required for some items in the maintenance plan. 1. Road conditions. a) Operation on bumpy,...

Engine oil and filter
Precautions when working with oils 1. Long-term and repeated contact with motor oil removes the natural oil layer from the skin, causing dryness, irritation and dermatitis. In addition, the motor oils used contain...

Cooling liquid
Examination 1. Remove the radiator cap. 2. Make sure the coolant level is level with the radiator filler neck. 3. Make sure that the coolant level in the expansion tank on a cold engine is between the "MAX" (A) and...

Checking and replacing the air filter
1. Remove the air filter cover (see the figure "Checking and replacing the air filter"). Tightening torque - 3 Nm Checking and replacing the air filter (engine K20A). Checking and replacing the air filter (d17 engine)....

Replacing the cabin filter
1. Open the glove compartment. 2. Remove the clamps. 3. Remove the cabin filter cover. 4. Remove the first filter. Slide the second filter to the right and remove it. 5. Remove the cabin filter from the housing and...

Attachment drive belts
1. Check the drive belts of the attachments for wear and damage. If any defects are found, replace the belts. Note: Separation of rubber from the cord on the inner side is not allowed (from the side of the ridges) and...

Checking spark plugs
Note: Depending on the equipment, vehicles are equipped with either iridium spark plugs or conventional spark plugs. 1. Disconnect the connectors from the spark plugs. 2. Using a spark plug wrench, remove the spark...

Checking the idle speed
1. Initial conditions of verification: a) The MIL indicator does not light. b) Clean air filter. 2. (When using a tachometer) Connect the tachometer lead (A) to the connector (B). 3. (When using a scanner) Connect the...

Checking the idle speed increase system
1. (When using a tachometer) Connect the tachometer lead (A) to the connector (B). 2. (When using a scanner) Connect the scanner to the diagnostic connector. 3. Measure the crankshaft speed 10 seconds after starting...

Checking the ignition timing angle
1. Start the engine. Set the speed to 3000 rpm without load until the cooling fan starts to run, then set the speed to idle. 2. Check the idle speed. 3. Install the scanner or special device as shown in the figure. 4....

Checking the end of compression stroke pressure
Warning: Engine parts or engine oil can cause burns. Use caution when removing or installing any parts. 1. Make sure the battery is fully charged. Charge the battery if necessary. 2. Warm up the engine to normal...

Checking the level and replacing oil in the manual transmission
Checking the oil level 1. Place the vehicle on a flat, horizontal surface. 2. Unscrew the filler plug (A) and remove the gasket (B). 3. Make sure that the oil level (C) is level with the lower edge of the filler hole....

Checking the level and replacing the working fluid of the automatic transmission
Checking the level 1. Start the engine and wait until the cooling fan starts. 2. Place the vehicle on a flat, horizontal surface. 3. Remove the automatic transmission fluid level dipstick (A), wipe it with a rag and...

Checking the level and replacing the CVT working fluid
Checking the level 1. Start the engine and wait until the cooling fan starts for the second time. 2. Place the vehicle on a flat, horizontal surface. 3. Remove the dipstick, wipe it with a rag and reinstall it. 4....

Checking the level and replacing the oil in the rear gearbox
Checking the level 1. Place the vehicle on a flat, horizontal surface. 2. Unscrew the filler plug (A) and remove the gasket (B). 3. Make sure that the oil level in the rear gearbox is at the lower edge of the filler...

Checking the clutch fluid level
Check the working fluid level on a cold, stopped engine. The working fluid level should be between the "MAX" and "MIN" marks. If the working fluid level is below the "MIN" mark, add working fluid of the same type that...

Checking the brake fluid level
Check the working fluid level on a cold, stopped engine. The working fluid level should be between the "MAX" and "MIN" marks. Sedan. Hatchback. If the working fluid level is below the "MIN" mark, add working fluid of...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)