Electrical equipment of the car engine Honda Civic 7

Starting system — starter
Checking the starting system circuit Note: Operations should be performed at a temperature of 15-38°. After performing the operations, it is necessary to erase the fault codes. It is recommended to use a starting system...

Checking the starter operation
Mitsuba (0.8 kW) Caution: To avoid damage to the stator winding, do not perform this test for more than 10 seconds. 1. (Mitsuba (0.8 kW)) Disconnect the wire from the starter terminal "S". 2. (Except Mitsuba (0.8 kW))...

Charging system — precautions
1. Make sure the battery cables are connected to the correct terminals. 2. When fast charging the battery, disconnect the wires from its terminals. 3. When measuring, do not use a high voltage tester with high input...

Charging system — check on the car
1. Check the density and level of electrolyte in each cell of the battery. 2. Check that the battery terminals are securely connected and that there is no corrosion on them. 3. Check fuses and fuse links. 4. Check the...

Generator — removal and installation
Removal and installation (D15B, D17A) 1. Disconnect the cable from the negative terminal of the battery. 2. Disconnect the "4P" connector (A) and the wire (B) from the "B" terminal of the generator, from the generator....

Generator — disassembly and assembly
Disassembly and assembly (K20A) Disassembly and assembly of the generator (K20A). 1 - bearing cover, 2 - rear bearing, 3 - rotor, 4 - front bearing holder, 5 - front bearing, 6 - generator drive pulley, 7 - generator...

Generator — check
Checking the rotor Electrical circuit of the generator. 1 - battery, 2 - engine compartment relay and fuse box, 3 - supply voltage control system unit, 4 - ignition switch, 5 - mounting block in the passenger...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code

Civic 8 (2005-2011)

Civic 7 (2000-2005)