2. Install the parking brake lever and washer onto the hinge pin and secure with a retainer.
Note: Snap the retainer securely to prevent the pivot pin from falling out of the brake shoe.
3. Connect the parking brake cable to the parking brake lever.
4. Apply lubricant to each sliding surface
Warning: Contaminated brake pads reduce stopping ability. Remove grease or oil from brake pads. Wipe excess grease from components.
Apply cylinder grease (P/N: 08733 B020E) or equivalent rubber lubricant to sliding surfaces as shown.
Apply Molycote 44MA to the ends of the brake pads and the opposing edges of the pads as shown.
5. Clean the threaded parts of the joints A and B. Coat the threaded parts of the joints with grease. To shorten the rod of the joints, tighten the adjusting bolt.
6. Aim the self-adjusting spring first at the self-adjusting lever, then at the brake shoe.
7. Install the ball joints and upper return spring, remembering the installation direction.
Note: Be careful not to damage the wheel cylinder protective caps.
8. Install the lower return spring.
9. Install the brake shoe spring retainers and thrust springs.
10. Install the brake drum.
11. If the wheel cylinder has been removed, bleed the brake system, check for leaks at the brake pipe connections, and tighten if necessary.
12. Press the brake pedal several times to set the brake self-adjustment,
13. Adjust the parking brake.
(The article was taken from the website: hondabook.ru)