 |
 |
2. Set piston #1 to TDC. The "UP" mark A on the camshaft sprocket should be on top, and the top dead center (TDC) marks B on the sprocket should be aligned with the top edge of the cylinder head.
3. Install the timing chain onto the crankshaft sprocket so that the colored chain link A is aligned with the TDC mark B on the crankshaft sprocket.
4. Install the timing chain onto the exhaust camshaft sprocket so that pointer A is aligned with the center of the two colored links of chain B.
 |
 |
5. Lubricate the threads of the timing chain tensioner mounting bolt A with engine oil.
7. Install the timing chain tensioner slider and tighten the bolt slightly.
8. Lubricate the sliding surface of the timing chain tensioner slider A with new engine oil.
9. Turn the timing chain tensioner slider clockwise to compress the chain tensioner and install the remaining bolt, then tighten the bolts.
 |
 |
10. Check if the timing chain housing oil seal is damaged. If the oil seal is damaged, replace the timing chain housing oil seal.
11. Remove any remaining old liquid gasket from the mating surfaces of the timing chain housing, bolts and bolt holes.
12. Clean and dry the mating surfaces of the timing chain housing.
13. Apply liquid sealant P/N 08C70-K0234M, 08C70-K0334M or 08C70-X0331S to the engine block mating surface of the timing chain housing.
Note: Apply a 1.5mm wide layer of sealant along damage line A.
Apply a 3.0 mm wide layer of sealant to the areas of surface B of the timing chain housing that are connected to the upper surfaces of the engine cylinder block,
If 5 minutes or more have passed since applying the liquid sealant, do not install the components. Instead, remove the old layer of liquid sealant and apply a new layer.
14. Install the pulse plate A and timing chain housing B.
Note: Wait 30 minutes before adding oil to the engine.
Do not start the engine for at least 3 hours after installing the timing chain housing.
15. Install the harness clamps A and connect the crankshaft position (CKP) sensor connector B.
 |
 |
16. Install the engine side mount bracket A, then lightly tighten the new nuts B and lightly tighten the bolt C.
17. Install the body ground cable D.
18. Remove the air cleaner housing assembly.
19. Loosen the transmission mounting bracket bolts and nuts A.
20. Tighten the side engine mount bracket mounting bolt and nuts.
21. Tighten the transmission mounting bracket bolts and nuts.
22. Install the oil pan.
23. Install the crankshaft pulley in place.
24. Install the cylinder head cover.
25. Install the water pump pulley.
26. Install the idler pulley.
 |
 |
28. Install the drive belt and adjust its tension.
29. Perform the Crankshaft Position (CKP) computer diagnostic procedure/CKP sensor reference position diagnostic procedure.