No movement (Honda Civic 5)

Trial

Attention.

To prevent damage to the transmission, do not test the transmission without moving for more than 10 seconds.

Do not shift the lever while increasing engine speed.

Make sure to remove the pressure gauge before attempting the no-run test.

1. Apply the parking brake and block the front wheels.

2. Connect the tachometer to the engine and start the engine.

3. Make sure the A/C switch is off.

4. After the engine has warmed up to normal operating temperature (radiator fan is on), switch to position [2].

5. Fully depress the brake pedal and accelerate the engine for 6 to 8 seconds with the throttle fully open, note the maximum engine speed.

6. Allow 2 minutes to cool, then repeat the test in [D4J] and [R] positions.

Note:

Testing without moving the vehicle should be performed for diagnostic purposes only.

The engine speed without movement should be the same in the [D4], [2] and [R] positions.

Position [1] is added to 7-position transmission.

Automatic transmission S4PA

Engine speed when testing without movement:

Engine D14A4

Standard: 2,500 rpm
Operating values: 2,350 - 2,650 rpm

Engine D15Z6

Standard: 2,650 rpm
Operating values: 2,500-2,800 rpm

S4XA; S4PA (Engines: D16Y4, D16Y6, D16Y9)

Standard: 2,800 rpm
Operating values: 2,650 - 2,950 rpm

Automatic transmission S4NA

Engine speed when testing without vehicle movement:

Nominal: 2600 rpm

Operating values: 2500 - 2700 rpm