Attention.
- Rotate the crankshaft pulley so that the piston of cylinder #1 is at TDC before removing the belt.
- When installing the timing belt, inspect the water pump.
1. Remove the crankcase guard
2. Remove the adjusting bolt and mounting bolts, then remove the power steering pump and drive belt.
3. Loosen the tension pulley bracket bolt and adjusting bolt, then remove the air conditioner compressor belt.
4. Loosen the mounting nut and mounting bolt, then remove the alternator drive belt.
5. Remove the top bracket
Note:
- Before removing the upper bracket, use a jack to support the engine.
- Make sure to place a shim between the oil pan and the jack.
6. Remove the lower power steering pump bracket.
7. Remove the crankshaft pulley.
8. Remove the cylinder head cover.
9. Remove the middle cover and bottom cover.
10. Loosen the adjusting bolt by 180°. Press the tensioner to loosen the timing belt tension, then tighten the adjusting bolt.
11. Remove the timing belt.