2. Disconnect 2P connector A of cigarette lighter B.
3. Check the connector terminals to make sure they are making good contact.
If the terminals are bent, loose, or corroded, correct them and recheck the connections.
If the terminals are OK, go to step 4.
4. Switch the ignition key to position «ACC» (I).
5. Check the voltage between terminal No. 1 of the cigarette lighter connector 2P and «weight» body. There should be battery voltage.
If there is battery voltage, go to step 6.
If there is no voltage, check:
Blown fuse #29 (20 A) or no. 35 (7.5 A) in the relay/fuse box under the control panel. o Faulty cigarette lighter relay. o Poor contact with «weight» V (G501, G503).
A break in the wire.
6. Check if there is a connection between terminal No. 2 and «weight» body. There must be a connection.
If there is a connection, go to step 7.
If there is no connection, check:
- Is the connection secure? «weight» at point G601.
- A break in the wire.
7. Install the accessory power socket in the reverse order of removal.