1. Raise the front of the vehicle and place safety supports in appropriate places.
2. Remove the front wheels.
3. Remove flange nut A and self-locking nut B while holding
the corresponding pins of the C joints using the Allen key D, and remove the stabilizer link E.
4. Install the link to the anti-roll bar F and shock absorber G, placing the pivot pins in the center of their range of travel.
5. Install the new flange nut and new self-locking nut. Then tighten them slightly.
6. Install the front wheels.
7. Gradually lower the jack.
8. Tighten the flange nut and self-locking nut to the recommended torque while holding the corresponding hinge pins with an Allen key.
You will find the original on the portal HondaBook.ru