Vehicle owner's manual Honda Fit/Jazz 1

Abbreviations and symbols
Abbreviations A/C - air conditioner ABS — anti-lock braking system AT, A/T — automatic transmission CVT — continuously variable transmission ECU — Electronic Control Unit EGR - exhaust gas recirculation system EPS —...

Vehicle identification
Engine specifications Note: The given power and torque values (JIS standard) are approximate and may vary depending on the specific modification and year of manufacture, but in most cases the error does not exceed ±5%....

Engine number and identification plates
The engine and transmission number plates are located as shown in the figure. 1 - body number, 2 - body brand, body number, 3 - transmission number (variator), 4 - transmission number (manual transmission), 5 - engine...

General repair instructions
1. Use fender covers, seat covers and floor mats to protect your car from dirt and damage. 2. When disassembling, arrange the parts in the proper order to facilitate subsequent assembly. 3. Observe the following rules:...

Garage jack and lift paw mounting points
Installation points for the lift legs. A - lift paw, B - the installation point of the lift paw. Installation points for the trolley jack.

Door lock
Caution: When working inside a vehicle equipped with an airbag and seat belt pretensioner system (SRS), be especially careful not to damage the SRS control shock. To avoid accidental deployment of the airbags or seat...

Odometer and trip meter
Odometer and trip meter. a) The odometer shows the total mileage of the vehicle. b) Odometers show the distance the vehicle has traveled since the last time the odometer was reset to zero. c) The "ODO/TRIP" button is...

Tachometer — General Information
Tachometer - shows the number of revolutions of the engine crankshaft per minute (rpm). Note: While driving, watch the tachometer readings. Its needle, which shows the engine crankshaft speed, should not enter the red...

Fuel quantity indicator
The indicator shows the fuel level in the fuel tank (F - full tank, E - empty tank) when the ignition key is in position "II". The low fuel indicator lights up when the fuel level in the tank is less than 6 liters....

Instrument cluster indicators
1. Turn signal indicators. The indicators flash when the turn signals or hazard warning lights are on. Excessive flashing of the indicators indicates a poor connection in the turn signal circuit or a failure of the turn...

Window lifters — general information
On models with electric door window lifts, the position of the windows and doors is adjusted by pressing the corresponding switch. In this case, the key in the ignition switch must be set to position "II". From the...

Light signaling in the car
1. Turning on the side lights, headlights, instrument cluster and license plate lighting. Note: The headlight and turn signal switch operates regardless of the position of the key in the ignition switch. a) When you...

Headlight range correction system
The adjustment of the beam direction of the headlights is carried out by rotating the regulator. The need to adjust the beam of light of the headlights arises depending on the vehicle load. This function can only be...

Hood and tailgate
1. To open the hood, you must perform the following procedures: a) Pull up on the hood lock release lever as shown in the figure. b) Raise the hood slightly and pull the hood lock lever up. c) Raise the hood and secure...

Fuel filler neck hatch
The fuel filler flap is opened manually.

Windscreen wiper and washer control
The windshield wiper and washer control switch operates when the ignition key is in position "II". 1. To turn the cleaner on and off, move the switch to one of the positions: "OFF" - full stop; "INT" - intermittent...

Adjusting the position of the steering wheel
To adjust the vertical position of the steering wheel, pull the locking lever down. Further adjustment is made by moving the steering wheel vertically, while the steering wheel tends to take the highest position, since...

Mirror control
Mirror adjustment is performed from the mirror control panel. The ignition key must be in position "II". The selection of control of the right or left mirror is carried out by setting the switch shown in the figure to...

Seats — General Information
1. Adjusting the longitudinal position of the front seats. To adjust the longitudinal position of the seats, move the lever up and move the seat to the desired position. After adjustment, return the lever to its...

Seat belts
To protect you and your passengers in the event of a traffic accident, it is recommended that all people in the vehicle wear seat belts. Attention: Do not wear the shoulder portion of the belt so that it passes under...

Precautions when operating vehicles equipped with the SRS system
The SRS airbags are designed only as a supplement to the primary safety belt system on the driver and front passenger sides. The driver and front passenger should be aware that if they are not properly fastened with...

Luke — General Information
The hatch can be operated when the ignition key is in position "II". The hatch can be in two different open positions: slid and open at an angle. Opening and closing the hatch Caution: When closing and opening the...

Heater and air conditioner control
The operation of the air conditioner and heater is controlled from the control panel. 1. To turn on the heater, move the heater fan speed switch (5) from the "OFF" position to any other position (models with mechanical...

Rear window defroster
If the rear window fogs up, press the switch (1) (models with mechanical control) or (3) (models with automatic control) of the rear window heater, located as shown in the figure. Models with automatic control of...

Instrument panel
Instrument panel from the driver's side. 1 - radio, 2 - hazard warning switch, 3 - windshield wiper and washer control switch, 4 - downshift switch in manual shift mode, 5 - manual shift upshift switch, 6 - headlight...

Location of components in the car interior
Location of components in the car interior. 1 - sun visor, 2 - interior rear view mirror, 3 - local lighting lamp/front interior lighting lamp, 4 - hatch, 5 - adjustable belt fastening, 6 - rear passenger compartment...

Replacing the cabin filter
1. Open the glove compartment. 2. Remove the lower part of the glove compartment. 3. Press the latches on the left and right of the cabin filter housing and remove it. 4. Remove the filter from the housing. Install the...

Radio tape recorder — main points of operation
Radio The quality of radio signal reception may vary significantly while the vehicle is moving due to terrain features, weather conditions, and proximity to sources of electromagnetic radiation. CD player In cold...
There is 1 a comment

Anti-lock braking system (ABS)
Caution: Use tires of the same size, design and load capacity as the original tires on the vehicle, as using tires of a different type may interfere with the proper operation of the anti-lock braking system. 1....

Emergency Brake Assistance (EBA)
The system recognises an emergency braking situation and automatically increases the brake pressure, thereby ensuring maximum braking force. The system provides emergency braking when the driver presses the brake pedal...

Driving a car with automatic transmission
To control the automatic transmission, a selector is installed on the central console. The selector is connected to the valve block by a cable, and with its help you can set the range of gears used. To prevent...

Driving a car with a CVT
To control the variator, a selector is installed on the central console. The selector is connected to the variator by a cable and can be used to set the variator operating mode. To prevent variator breakdowns due to...

Driving a car with a manual transmission
The gear layout diagram is shown in the figure. The diagram is also depicted on the lever handle. Always fully depress the clutch pedal before changing gears. Attention: Do not keep your foot on the clutch pedal while...

Features of the transmission of 4WD models
Caution: To avoid damage to transmission components, partial towing (lifting only one axle of the vehicle) is prohibited for 4WD models. 4WD models have automatically engaged all-wheel drive. The rear axle is connected...

Tips for driving in different conditions
General recommendations Attention: Before driving, make sure that the parking brake is fully released and the corresponding indicator is off. Do not keep your foot on the brake pedal while driving. This can lead to...

Towing a car
Attention: it is strictly forbidden to tow 4WD vehicles using the partial loading method, i.e. lifting one of the vehicle axles. Note: towing of vehicles with automatic transmission is permitted at a speed of no more...

Starting the engine
Ignition switch There are four fixed positions of the key in the ignition switch: 0: In this position, the key can be inserted or removed from the ignition switch. When the key is removed, the steering wheel is locked....

Engine malfunctions while driving
Engine stops while driving 1. Reduce speed gradually. Move the car to a safe place. 2. Turn on the hazard warning lights. 3. Try to start the engine. Note: When the engine is not running, the brake and power steering...

Spare tire, jack and tools
The spare tire, jack and tools are stored in the luggage compartment as shown in the figure. 1. Lift up the luggage compartment carpet and secure it as shown in the figure. 1 - spare wheel, 2 - jack, 3 - tool. 3. Remove...

Jacking up a car
1. Place the vehicle on a level and firm surface. 2. Turn off the engine, apply the parking brake and block the wheel diagonally opposite the one to be replaced. 3. Place the jack only in the places specially designated...

Wheel replacement
1. If you need to change a tire on the road, gradually reduce speed and move the car to a safe place. 2. Stop the vehicle on a level place with firm ground. 3. Stop the engine and turn on the hazard warning lights. 4....

Recommendations for choosing tires
When choosing tires, pay attention to the marking. The geometric dimensions, load capacity and maximum speed must strictly comply with the manufacturer's recommendations. The landing diameter of the selected tire must...

Checking tire pressure and condition
1. Check your tires regularly for damage. Check your tire pressure every two weeks or at least once a month. Don't forget to check the pressure in your spare tire. The Honda recommended tire pressure for your vehicle's...

Tire replacement
1. When replacing tires, use only tires of the same size and design as those originally installed, and with the same or greater load capacity. Using a tire of any other size or type may seriously affect handling,...

Features of using aluminum wheels
Caution: To avoid damaging the protective varnish layer, do not allow tire shop workers to clean the outer surface of the rim with a wire brush or remove adhesive balancing weights with a screwdriver when replacing...

Replacement of wheel disks
1. Due attention should be paid to replacing wheel rims. Make sure that rims with the same load capacity, diameter, rim width and offset are installed. 2. Incorrect selection of wheels and tires can adversely affect...

Brake Column Lining Wear Indicators
The pads for disc brakes are equipped with wear indicators in such a way that when driving, when the thickness of the pads is minimal, the wear indicator touches the brake disc and the brakes make an unpleasant sound...

Catalytic converter and exhaust system
1. The catalytic converter is a device for reducing the toxicity of exhaust gases. When operating a vehicle equipped with a catalytic converter, observe the following precautions: a) During and after engine operation,...

Checking and replacing fuses
If the headlights or other electrical components do not work, check the fuses. If any of the elements are burnt out, they must be replaced. Note: To remove and install type "A" fuses, use a special "tweezers" type...

Replacing lamps
Attention: Before replacing the lamp, make sure the light switches are turned off. To avoid burns, replace lamps only after they have cooled down. Halogen lamps require special care. Do not touch the glass part of the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code