2. Turn off the engine, apply the parking brake and block the wheel diagonally opposite the one to be replaced.
3. Place the jack only in the places specially designated for it, as shown in the figure.
Sedan.
Hatchback (five-door models).
Hatchback (three-door models).
Attention:
- Install the jack only in the recommended position. If the jack is installed incorrectly, it may cause dents in the car body or the jack may fall, injuring you.
- Avoid installing the jack on a slope or unstable surface. Otherwise, the jack may tilt and move from the installation position or fall, which may cause an accident. Always install the jack on a flat, hard surface.
- Before installing the jack, make sure that there is no sand or small stones on the supporting surface.
- Never stand under a vehicle when the vehicle is supported only by a jack. The jack may tilt and move from its mounting position or fall, which could cause an accident.
4. Install the jack handle as shown in the figure.
5. Turn the handle to the right to jack up the car.
6. After completing the work, lower the vehicle and fold the jack.
The original is located on the website: HONDABOOK.ru