Instruments, control and signal lamps Speedometer Shows the speed in km/h. When the ignition key is turned to position «II» total or current mileage is displayed. Display switching When the button is pressed briefly, a sequential switch occurs «general,...
Indicator lamps Separate indicator lamps may not be available on some models. Turn signal indicator Simultaneously flashing direction indicators. Instruction. When the light bulbs burn out, the load (power consumption) decreases and...
Pilot lamps Oil pressure warning lamp Lights up when the oil pressure drops, which lubricates the engine during operation. If the lamp comes on while the engine is running, immediately stop the engine in a safe place and check the...
Egnition lock 0 - Position for inserting and removing the ignition key. I - A position in which power is supplied to individual devices, such as a radio, without starting the engine. II - Driving position. III - Engine start...
Headlight switch Turning the headlights on and off Regardless of the position of the ignition key, turning on and off the headlights is carried out as follows. Instruction. When the engine is off, do not leave various lights on for a...
Turn signal switch Used when the ignition key is in position «II». Commonly used in positions «1». In such positions, with a small steering angle, the lever may not return to its original position. In this case, the lever is returned...
Hazard indicator lamp When the button is pressed, all direction indicator lamps flash. Used when towing a broken vehicle. Instruction. Use this button only in emergency situations. Even with a fully charged new battery, after about 2 hours,...
Wiper/Washer switch Operates when the ignition key is in position «II». Windshield Wiper switch OFF - Stop INT (intermittent work) - In light rain LO (low speed) - In moderate rain HI (high speed) - In heavy rain Intermittent operation of...
Rear window heater If the ignition key is in the position «II», to turn on the heater, press the button, and the indicator lamp will light up. If the button is pressed a second time, the heater switches off and the indicator light goes...
Horn switch The horn is activated when the steering wheel pad is pressed.
Engine start procedure Warning! Do not start the engine when the electrolyte level in the battery is low. There is a risk of battery failure. Do not start the engine in a garage or other poorly ventilated area. Exhaust gas accumulates in the...
Parking brake Tightening the brake Press the button and fully raise the lever. The parking brake acts on the rear wheels. Releasing the parking brake 1. While slightly lifting the lever, press the button. 2. Without releasing the...
Gear lever (models with manual gearbox) Gear lever Fully depress the clutch pedal when shifting gears. When reverse gear is engaged («R») To avoid erroneous shifting directly from 5th gear, it is impossible to switch to reverse «R». First you need to shift...
Selector lever (models with automatic transmission) Operation in various lever positions P - Parking. Position when parking or starting the engine. The position in which the ignition key is removed. Note: If the selector lever is in a position other than «R», the...
Airbags Instruction. When carrying out repairs near the steering column, dashboard or center console, when installing a radio receiver, the airbag system may be accidentally damaged. Therefore, before carrying out this kind of...
Seat belt pretensioner Seat belt tightening In a frontal collision, the front seat belt retracts instantly. The pretensioner deploys under the same conditions as the airbag. How the system works When the ignition key is in position «II» and...
Anti-Lock Braking System (ABS) During sharp maneuvers or when driving on a slippery road, it eliminates the blocking of the wheels and makes the grip of the wheels stable, therefore steering is maintained. When you press the brake pedal, you can feel...
Models J4, JS4 with 4 wheel drive (4WD) 4WD vehicles have a huge advantage over 2WD vehicles on sandy, snowy, mountainous and slippery roads. When driving, follow these guidelines. Avoid long trips on sandy and narrow roads where the front wheels can spin....
Heating and air conditioning with automatic control Usual way of application 1. Press the AUTO button. 2. The required temperature in the cabin is set, which is displayed on the indicator. To turn off the air conditioner, press the OFF button. Note: To prevent cold...
Manual heater/air conditioner Air direction switch knob Rapid heating of the cabin Prevention of fogging of glasses and warming up the cabin Removing ice or fogging from the windshield or side windows When the humidity is high, such as during rain...
Car tool, spare wheel, squib The igniter is located on the left at the feet of the front passenger. Type of on-board tool Note: In order to act correctly in a critical situation, study the rules for using the on-board tool in advance. To prevent...
Towing a car The vehicle is towed on the platform of a towing vehicle with four or two wheels raised. If the wheels do not turn, it can be assumed that there is a breakdown in the gearbox, so be sure to tow the car with the 4th...
The procedure for using the jack Jack removal procedure Loosen the jack brace and remove it. Instruction. When installing the jack in place, do not burst it with great force, as this may damage the seat. Locations for jacking Jack installation 1. The...
Spare wheel 1. Slide the luggage compartment cover back, lift the front part up, remove the rod from the groove and remove the cover. 2. Loosen the fixing screw. The spare wheel is only used in the event of a tire puncture. When...
Wheel replacement First steps 1. Stop the vehicle on a level, safe place and remove the tools and spare wheel. 2. Apply the parking brake firmly. A wheel located diagonally with a puncture is blocked in front and behind with the help of,...
Light fixture failures If the battery is charged, then it can be assumed that the fuses have blown or the lamps have burned out. 1. Turn the ignition key to position «0». 2. Check the integrity of the fuses. 3. Replace fuse and bulb if...
Replacement of electric lamps If the fuses are not blown, and some lamps do not light, it can be assumed that they have blown. It is necessary to check the operability of the lamps and replace the burnt ones. Note: When removing the lamp or lens,...
Wheel swap Every 5000 km of run it is necessary to rearrange the wheels. This is done in order to eliminate uneven tire wear, to extend their service life and improve driving performance. Wheel direction marks Some types of tires...
Vehicle technical data Recommended engine oil Honda engine oil or API SG oil is recommended. Select the oil viscosity according to the expected outside temperature, see table.
Vehicle identification numbers Pic. 1 Locations of identification numbers: 1. Vehicle identification number 2. Certification label (KG, KE, KN, KQ, KU, KT) 3. Gearbox number (mechanical) 4. Gearbox number (CVT / Multi Matic) 5. Engine number 6....
Warning/Caution Label Locations 1. Information about the airbag (NPB) for the driver 2. Caution regarding the installation of a child seat on a front passenger seat equipped with an airbag 3. Front passenger airbag warning 4. Front Seat Belt...