Piston pins — removal (Honda Civic 5)

Note: To remove the piston pins, use only the special piston pin removal tool kit (07AP-0010000). Make sure you are using the correct number guide bushing.

1. Install special tools as shown.

2. Place the piston on the special tools and press out the pin using a hydraulic press.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Mikhail Kopasov

◀ Previous

Civic 5 and 6: Engine overhaul

Next ▶

Cylinder block
Pistons — inspection
Crankshaft — inspection
Pistons and crankshaft
Connecting rod bearings

Connecting rods — selection
Piston pins
Clearance in the piston ring lock
Installing the seal
Pistons — installation

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Civic 8 (2005-2011)

Civic 7 (2000-2005)

General information
User manual
Maintenance
Power unit
Engines D15B and D17A
K20A Engines
Overhaul engine
Cooling system
Lubrication system
Fuel injection system
Toxicity reduction system
Engine electrical equipment
Transmission
Clutch
Manual gearbox
Automatic gearbox
Variator (CVT)
Drive shafts
Chassis and running gear
Car suspension
Steering
Brake system
Body and interior
Exterior (external elements)
Interior (internal elements)
Doors, locks and windows
Heater and air conditioner
Manual air conditioner
Automatic air conditioner
Security system
Electrical equipment
Equipment and devices
Headlights and lighting
Windscreen wipers
Audio system
Electrical diagrams