Examination
1. Remove the wheel cap.
2. Raise the car and place a swivel stand under the front wheels and place a panel of the same thickness under the rear wheels/then lower the car.
Note: Make sure the machine is in a horizontal position with the wheels on the swivel stand and panel.
3. Install the wheel position sensor adapter and camber/kingpin sensor onto the wheel hub and apply the brake.
4. Turn the front wheel 20" outward, turn the adjusting screw so that the bubble in the camber/king pin sensor is at 0".
5. Turn the wheel 20" inward and look at the inclination of the kingpin when the bubble is in the center of the scale.
Kingpin angle
6. If not within specification, check for bent or damaged suspension parts.