Contents: Removal ⇊ Replacing the seal and bearing ⇊
Removal
Note: Replacing the inner seal and bearing requires special tools.
1. Loosen the left wheel mounting nuts, lift the front of the car, support it with stands and remove the wheel.
2. Drain the oil from the gearbox (see Chapter 1).
3. Remove the three bearing support mounting bolts.
Fig. 2.3 Bolts for fastening the support to the engine (arrows)
4. Carefully lower the support a few centimeters and, supporting the intermediate shaft at both ends, remove the shaft with the support from the differential. Do not damage the differential seal!
Replacing the seal and bearing
5. Remove the outer seal and snap ring from the bearing support.
Fig. 2.5 Assembly of the intermediate shaft and bearing support: 1 - outer seal; 2 - external retaining ring; 3 - intermediate shaft ring; 4 - support ring; 5 - intermediate shaft; 6 - inner seal; 7 - internal retaining ring; 8 - intermediate shaft bearing; 9 - support.
6. Further repairs must be carried out at a service station.
7. Installation is carried out in the reverse order of removal.
Material obtained from the website HondaBook.ru