2. Install new O-rings. Then install the sensors.
3. Make sure there is no rust, oil, dirt, etc. inside the connectors. Install the connectors tightly.
Intermediate and secondary shaft speed sensors — replacement (Honda Avancier 1)
1. Disconnect the connectors and remove the intermediate and secondary shaft speed sensors.
2. Install new O-rings. Then install the sensors.
3. Make sure there is no rust, oil, dirt, etc. inside the connectors. Install the connectors tightly.
2. Install new O-rings. Then install the sensors.
3. Make sure there is no rust, oil, dirt, etc. inside the connectors. Install the connectors tightly.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Electric valves A and B of pressure in the automatic transmission clutch —…
Automatic transmission clutch pressure solenoid valves A and B — checking
Electric valves B and C of gear shifting — replacement
Shift Solenoid Valves B and C — Check
Torque Converter Lockup Solenoid Valve and Shift Solenoid Valve Assembly —…
Automatic transmission clutch pressure solenoid valves A and B — checking
Electric valves B and C of gear shifting — replacement
Shift Solenoid Valves B and C — Check
Torque Converter Lockup Solenoid Valve and Shift Solenoid Valve Assembly —…
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits