Contents: Examination ⇊ Replacement ⇊
Examination
1. Disconnect the transmission shift solenoid connector.
2. Check the resistance between terminal "1" (gear shift solenoid valve "A") of the connector and ground and between terminal "2" (gear shift solenoid valve "B") of the connector and ground.
Resistance - 12-25 Ohm
3. Connect each connector terminal (terminal "1" - electromagnetic valve "A", terminal "2" - electromagnetic valve "B") to the positive terminal of the battery and check the operation of the electromagnetic valve: clicks should be heard.
Replace the shift solenoid valve if necessary.
Replacement
1. Remove the shift solenoid connector from the bracket (A) and disconnect the connector.
2. Remove the solenoid valves (B).
3. Replace the O-rings (C) with new ones and install a new solenoid valve.
Tightening torque - 12 Nm
4. Make sure there is no rust on the connector contacts and connect the connector to the shift solenoids.
5. Install the solenoid valve connector to the bracket.
You will find the original on the portal: HONDABOOK