Input shaft speed sensor (Honda Civic 7)

Replacement

1. Disconnect the transmission input shaft speed sensor connector.

2. Loosen the bolts and remove the sensor (A).

3. Install a new O-ring (B) onto the new transmission input shaft speed sensor.

4. Install the sensor and tighten the bolt.

Tightening torque - 12 Nm

5. Make sure there is no rust on the connector contacts and connect the connector to the transmission input shaft speed sensor.

(You will find the original on the portal HondaBook.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 7: Automatic gearbox

Next ▶

Pressure control solenoid valves
Gearshift Solenoid valves
Torque Converter Lockup Solenoid Valve
Start inhibit switch
Position sensor

Output shaft speed sensor
Selector — removal, installation
Gearbox control cable
Gearbox SLXA (2WD)
SSTA Transmission (4WD)