4-speed automatic transmission (AT) The location of the AT and its related components in the engine compartment of the car (bottom view) 1 - Amplifier of the power unit; 2 - Subframe; 3 - Gearshift cable; 4 - Switch cable holder; 5 - Shift cable cover...
AT/CVT Failure Diagnostics — General Information Note. AT failures most often occur for one of the following five reasons: reduced engine output efficiency, misadjustments, hydraulic failures, mechanical damage, or on-board processor/signal circuit failures. Failure...
Removal, installation and adjustment of a cable of a gear change Warning! The car models covered in this manual are equipped with an additional security system (SRS). Before doing any work near the airbag unit, steering column or instrument panel, turn off the SRS to avoid injury if...
Removal and installation of the shift lever (selector) of transfers Warning! The car models covered in this manual are equipped with an additional security system (SRS). Before doing any work near the airbag unit, steering column or instrument panel, turn off the SRS to avoid injury if...
Locking system — general information, check, replacement and adjustment Warning! The car models covered in this manual are equipped with an additional security system (SRS). Before doing any work near the airbag unit, steering column or instrument panel, turn off the SRS to avoid injury if...
Adjustment and replacement of the transmission position sensor-switch Examination 1. Access to the electrical wiring connector of the sensor-switch is possible from the engine compartment. 2. Disconnect the 10-track transmission position sensor-switch connector. 3. Check the connector for...
Checking and replacing the transmission control solenoid valves Examination 1. There are three pairs of transmission control solenoid valves to test: Lock/Shift Control Valve A, Shift Control Valves B and C, and Clutch Pressure Control Valves. Lock/Switch Control Solenoid A 2....
Removal and installation of 4-speed and automatic transmission (AT) Withdrawal 1. Disconnect the negative cable from the battery. Attention! If the stereo system installed in the car is equipped with a security code, before disconnecting the battery, make sure that you have the correct...