Car engine maintenance Honda Avancier 1

Checking and replacing the radiator cap
Caution: Do not open the radiator cap when the engine is hot, as the coolant is under pressure and may spill out. After the coolant has cooled, cover the cap with a rag and open it slowly. 1. Install the radiator cap...

Checking the level and adding coolant
Caution: When filling the coolant, be careful not to let it come into contact with the connectors, relay box and other electrical components. Cover the components with a protective film before filling. 1. Make sure that...

Checking and replacing engine oil
Caution: Before checking the oil level, turn off the engine and wait at least 3 minutes. Examination 1. Park the car on a level surface and turn off the engine. 2. Remove the oil dipstick and check the oil quantity and...

Replacing the oil filter
Replacement frequency: every 20,000 km* Under severe operating conditions - every 10,000 km. 1. Remove the oil filter using an oil filter wrench. 2. Apply engine oil to the seal of the new oil filter. Check the contact...

Measuring oil pressure
1. Install the tachometer (see chap. Engine management system ). 2. Unscrew the low oil pressure indicator lamp switch and install the oil pressure gauge (special tool). 3. Start the engine and warm it up until the...

Cleaning, checking and adjusting the spark plug gap
1. Perform the following check of the spark plugs and adjust or replace them if necessary: Check spark gaps Check the electrodes for contamination Check for carbon deposits Check the central electrode insulator for...

Checking the compression pressure
1. Warm up the engine until the radiator fan runs twice. 2. After warming up, turn off the engine. 3. To turn off the fuel pump, remove fuse No.1 (15A) from the fuse box located in the passenger compartment. 4. Start...

Checking and adjusting the tension of the alternator and air conditioning compressor belt
Attention: When checking the belt tension, check it for damage and replace it if necessary. If you are installing a new belt, adjust the tension, start the engine, wait 5 minutes, and then adjust again. 1. Check the...

Checking and adjusting the tension of the power steering pump belt
Attention: When checking the belt tension, check it for damage and replace the belt if necessary. If you are installing a new belt, adjust the tension, start the engine, wait 5 minutes, and then adjust again. 1. Check...

Adjusting valve clearances
Caution. The crankshaft pulley bolt has a right-hand thread. When turning the crankshaft counterclockwise using the pulley bolt, the bolt may come loose. After completing the work, tighten the crankshaft pulley bolt...

Checking the intake valve rocker arms as a whole
Hand check 1. Remove the valve cover. For valve cover installation, see below. 2. Press your finger on the center intake rocker arm (for high speed) of the intake valve and make sure that it moves independently of the...

Diagnostics of malfunctions of the VTEC system (electronic control of valve timing and valve lift)
Close the corresponding contacts of the service connector and check whether fault code No.21 (P1253) is displayed by the flashing of the PGM-FI indicator lamp. See the table of fault codes in Chapter. Engine management...

Checking the VTEC solenoid valve
1. Remove the solenoid valve assembly from the cylinder head and check the inlet filter for blockage. If the filter is clogged with dirt, replace the engine oil filter and change the engine oil. 2. If the inlet filter...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code