Note: Do not scratch the body.
1. Activate the windshield wiper switch and rotate the windshield wiper blades 90°.
2. Remove the central shield A.
Remove the rear hood seal B by pulling it outward.
Remove the C fasteners.
Unhook the two front hooks D located on the edge of the panel under the shield E.
Release the fasteners F by gently pulling the shield upwards, then remove it by unhooking the hooks G. Avoid scratching the body.
3. Disconnect the windshield washer pipes H.
4. Remove the following parts:
- windshield wiper arms;
- trim of the front wing on both sides.
5. Disconnect the clips by carefully lifting the side shield cover A, then remove the shield by unhooking the hooks B from the front fender. Do not scratch the body. Repeat this step for the other side shield cover.
6. Install the panel in the reverse order of removal. Note the following: Check the clips for damage or whitening from stress and replace them with new ones if necessary.
Make sure the washer tube is securely fastened.
Place the clamps securely in place.
(Publication reprinted from the website HondaBook.ru)