Replacing the hood seal (Honda Civic 8)

1. Using a clip remover, release the clips, then remove the hood seal A. Be careful not to damage the paint finish of the hood.

2. Install the seal in the reverse order of removal, check the clips for damage or whitening from the load and replace them with new ones if necessary.

[Article source on the website: www.HondaBook.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 8: Exterior (external elements)

Next ▶

Replacing the hood release lever
Replacing the hood lock
Replacing the hood insulator (for some models)
Adjusting the hood
Replacing the front wheel arch protector

Removal the front side pillar trim
Windshield Shield Replacement
Front Fender Trim Replacement
Replacing the rear wheel arch protector
Roof Molding Replacement