Removal and installation
1. Jack up the car and place it on stands.
2. Remove the front wheels.
3. Hold the ball joint pin (B) with the Allen key (C) and loosen the stabilizer bar strut mounting nut. Disconnect the strut (D) from the stabilizer (A).
Tightening torque - 39 Nm
4. Loosen the bolts, remove the bracket (C) and bushing (B) of the stabilizer bar mount, then remove the stabilizer bar (A).
Note:
- Installation is carried out in the reverse order of removal.
- When installing:
- use only new mounting nuts;
- install the stabilizer mounting bracket with the arrow facing forward;
- install the mounting bushings (A) according to the mark (B), as shown in the figure.
- After installation, check the front wheel alignment angles.
Replacing the stabilizer bar
1. Jack up the car and place it on stands.
2. Remove the front wheels.
3. Hold the pin (C) of the ball joint (B) with the Allen key (D), and loosen the stabilizer link mounting nuts. Disconnect the stabilizer link from the front suspension lower arm (A) of the stabilizer.
4. Install the new stabilizer bar as shown in the figure.
Note: When installing the strut, jack up the lower arm of the front suspension to align the holes with the ball joint pins.
5. While holding the ball joint pin (B) with the Allen key (C), tighten the stabilizer bar mounting nuts (A and D).
Tightening torque - 39 Nm
6. Install the front wheels.
7. Remove the vehicle from the stands.
(The original is located on the website www.hondabook.ru)