Rear suspension anti-roll bar (Honda Civic 7)

Removal and installation

1. Jack up the rear of the vehicle and place it on stands.

2. Remove the rear wheels.

3. Hold the ball joint pin with a hex key and loosen the stabilizer bar mount nut. Disconnect the strut from the stabilizer.

Tightening torque - 38 Nm



4. Loosen the bolts, remove the stabilizer mounting bracket and bushing, then remove the anti-roll bar.

Note:

- Installation is carried out in the reverse order of removal.

- When installing:

• use only new mounting nuts;
• install the mounting bushings according to the mark as shown in the figure.

- After installation, check the rear wheel alignment angles.

Replacing the stabilizer bar

1. Jack up the rear of the vehicle and place it on stands.

2. Remove the rear wheels.

3. Hold the ball joint pin with a hex key and loosen the stabilizer bar mounting nuts. Remove the stabilizer bar.



4. Install the new stabilizer bar as shown in the figure.

Note: When installing the strut, jack up the lower arm of the front suspension to align the holes with the ball joint pins.

5. While holding the ball joint pin with a hex key, tighten the stabilizer bar mounting nuts.

Tightening torque - 39 Nm





6. Install the rear wheels.

7. Remove the vehicle from the stands.

(The text of the article is available on the website: www.hondabook.ru)