Contents: Control ⇊ Replacement ⇊
Control
1. Disconnect the negative cable from the battery.
2. Additional resistors are located in the left part of the engine compartment.
3. Find the resistance connector along the wires and break the electrical contact.
4. Measure the resistance between terminals A and each of the four injector power terminals. The resistances should be in the range of 5-7 ohms.
Fig. 16.4 Connector and contacts of additional resistors. A — main power terminal
5. If the measured resistance is outside the acceptable range, replace it.
Replacement
6. Unscrew the bolts securing the resistor block from the housing and remove the block.