1. The relay is located:
- on CR-V models - in the passenger compartment on the passenger side, under the instrument panel,
- on Odyssey 2.2/2.3L models - in the passenger compartment on the driver's side, under the instrument panel,
- on Odyssey V6 models - to the left of the steering column, under the instrument panel
2. Apply voltage from the battery to terminal 3, connect terminal 2 to ground and check the circuit between terminals 2 and 5.
3. If there is no circuit, replace the relay.
4. If there is a circuit, connect terminal 4 to the positive terminal of the battery, connect terminal 2 to ground and check the circuit between terminals 2 and 5.
5. If there is a circuit, then the relay is working properly. Otherwise, replace the relay.
Injection relay diagram: 1. Battery voltage; 2. Relay; 3. Resistor; 4. Fuel pump; 5. Pump relay; 6. Signal from the starter; 7. From the ignition switch
Injection relay terminals: 1. Connector; 2. Connector terminals; 3. To the fuel pump; 4. To the PCM connector - block; 5. To the starter switch; 6. On mass; 7. To the ignition switch; 8. To the battery