Note: Check the clutch pedal position sensor.
Before adjusting the clutch pedal, remove the mat from the driver's side.
To compensate for wear, the clutch is self-adjusting.
If there is no clearance between the clutch master cylinder piston and the pushrod, the release bearing can impact the diaphragm spring, which in turn can cause slippage or other clutch problems.
1. Loosen lock nut A, and turn the clutch pedal position switch or adjusting bolt B so that it does not touch the clutch pedal.
2. Loosen the lock nut D and, by turning the clutch master cylinder rod, set the required pedal height F, full pedal travel G, free pedal travel H, and full clutch disengagement position I.
- Full travel of the clutch pedal: 120-130 mm.
- Clutch pedal free travel: 10-18 mm.
- Clutch pedal installation height: 67 mm.
- Pedal position with clutch fully disengaged: 149 mm.
3. Tighten the lock nut.
4. With the clutch pedal released, tighten the position switch or clutch pedal adjustment bolt until the pedal touches.
5. Tighten the position switch or clutch pedal adjustment bolt an additional 3/4-1 turn.
6. Tighten the lock nut.
7. Press the clutch pedal to the floor.
Original material on the website hondabook