Contents: Pedal height ⇊ Free pedal travel ⇊
Pedal height
The height of the pedal position is the distance from its pad to the floor panel. If the measurement result of this distance is outside the permissible range, it is necessary to make the appropriate adjustment.
To adjust the pedal position, loosen the lock nut of the clutch switch sensor or the adjusting bolt and turn the switch so that it no longer touches the pedal. Now loosen the lock nut of the pusher and, by turning the latter, adjust the height of the pedal position as required. Tighten the lock nut.
Note: The clutch switch is the lower of two units located next to each other (the upper unit is the starter circuit breaker switch). Rotate the switch/bolt clockwise until it contacts the pedal arm, then turn it an additional 3/4 turn/turn. Tighten the lock nut.
Adjust the starter circuit breaker switch (see Section Checking the condition, replacing and adjusting the starter circuit breaker switch sensor).
Free pedal travel
Free play is the distance the pedal moves without encountering resistance and without causing the clutch to engage. If the pedal free play is outside the permissible range, it is necessary to make the appropriate adjustment. To adjust the free play, loosen the lock nut on the pedal pusher, then rotate the pusher until the desired result is achieved. Tighten the lock nut.
Make sure that the starter circuit breaker switch is adjusted correctly (see Section Checking the condition, replacing and adjusting the starter circuit breaker switch sensor).