Replacing the fuel pressure regulator (L13A) (Honda Civic 8)

1. Remove the fuel tank block.

2. Remove clamps A and remove fuel pressure regulator B.

3. Install the part with new sealing rings C in the reverse order of removal. When installing the fuel pump/fuel level gauge assembly, align the marks on the block and on the fuel tank.

Note: Lubricate the O-ring with engine oil. Do not pinch the O-rings when installing. Do not use brake fluid, vegetable oil or alcohol-based oil on the O-rings.

(The original can be found on the resource HondaBook)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 8: Injection system (gasoline)

Next ▶

Installation of fuel line connectors for the fuel system (L13A)
Removal the fuel line connectors of the fuel system (L13A)
Checking the fuel level indicator transmitter (L13A)
Replacing the fuel filter (L13A)
Checking the suction pipe and fuel vent line (L13A)

Replacing the fuel level indicator transmitter (L13A)
Troubleshooting the Fuel Pump Circuit (L13A)
Removal and installation the fuel tank (L13A)
Replacing the inertia switch (L13A)