2. Apply a small amount of sealant to 2-3 threads of the oil pressure sensor and install it.
Note: Using too much sealant may cause the oil passage to become clogged.
[The original text of the article is located on the website: www.hondabook.ru]
Replacing the oil pressure sensor (Honda Fit 1)
1. Disconnect the oil pressure sensor connector and unscrew the sensor.
2. Apply a small amount of sealant to 2-3 threads of the oil pressure sensor and install it.
[The original text of the article is located on the website: www.hondabook.ru]
2. Apply a small amount of sealant to 2-3 threads of the oil pressure sensor and install it.
[The original text of the article is located on the website: www.hondabook.ru]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)