Car steering Honda Fit/Jazz 1

Check on the car
Checking the steering wheel play With the vehicle stationary and the wheels set to the straight-ahead position, rock the steering wheel from side to side with a little effort. If the play does not meet the established...

Steering wheel — removal
Warning: Careless handling of the air bag may cause it to deploy unintentionally, which may cause serious injury. Before removing the air bag, read the Operation and Maintenance Precautions section in Chapter "...

Steering wheel — installation
1. Make sure the wheels are set in the straight ahead position. 2. Install and adjust the spiral wire. a) Install the spiral wire. b) Turn the spiral wire clockwise until it stops. c) Turn the spiral wire...

Removal and installation the steering column
Note: Installation is carried out in the reverse order of removal. When removing and installing the steering column, refer to the corresponding assembly drawings. 1. Disconnect the cable from the negative terminal of...

Removal and installation the steering gear
Note: Installation is carried out in the reverse order of removal. When removing and installing the steering gear, refer to the corresponding assembly drawings. 1. Disconnect the cable from the negative terminal of the...

Steering wheel — device
Steering wheel (left-hand drive models). 1 - steering wheel cover, 2 - cruise control system control switch, 3 - sound signal plate, 4 - wiring harness, 5 - manual gear downshift switch, 6 - steering wheel, 7 - manual...

Removal and installation the power steering motor
Note: Installation is carried out in the reverse order of removal, taking into account the following: Before installing the motor, apply grease to the motor shaft or worm shaft splines and silicone grease to the sealing...

Left-hand electric power steering diagnostic system «Honda Diagnostic System»
1. Start the engine and check the indicator. Note: When the ignition key is in the "ON (II)" position and the engine is not running, the indicator light comes on for a few seconds and then goes out. 2. If the indicator...

Erasing left EPS electric power steering codes
Note: If during or immediately after deleting codes (when the "SGS" output is shorted to ground) the engine is started, the system will go into code reading mode. Codes stored in the EEPROM memory cannot be erased by...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code