Car steering Honda CR-V 1

Steering wheel — removal and installation
Removal 1. Disconnect the battery from ground. 2. Disable the pneumatic safety system ( Chapter 6 ). 3. To access the wiring, remove the trim at the bottom of the steering wheel. 4. Remove the connector connecting the...

Combination switch — removal and installation
1. Disable the pneumatic safety system ( Chapter 6 ). 2. Remove the lower instrument panel cover and knee pad. 3. Remove both steering column covers. 4. Disconnect the connector by pressing the latch. 5. Loosen the...

Contact part of the ignition switch — removal and installation
1. Disable the pneumatic safety system ( Chapter 6 ). 2. Remove the lower instrument panel cover and knee pad. 3. Remove the steering column covers. 4. Disconnect the wiring from the fuse box. 5. Remove the upper and...

Ignition switch — removal and installation
Removal 1. Disable the pneumatic safety system ( Chapter 6 ). 2. On CR-V and Odyssey 76 vehicles, remove the steering column as follows: a. Remove the steering wheel b. Remove the lower cover of the delivery panel and...

Inner steering rods
Removal 1. Raise the vehicle and remove the wheel. 2. Clean the outer tie rod down to the tie rod end lock nut. 3. Loosen the outer tie rod end lock nut by 1/8 turn. 4. Loosen the clamps of the dust cover, remove the...

Outer tie rod ends
Removal 1. Raise the car, remove the wheel. 2. Loosen the outer tip lock nut 1/8 turn. 3. Mark the position of the tie rod end relative to the end of the inner rod. 4. Unscrew the crown nut of the tip, press the...

Power steering gear — removal and installation
Removal 1. Drain the fluid from the power steering circuit: a. Raise the power steering reservoir and disconnect the inlet hose. b. Attach a tube to the inlet hose and lower the other end into the container. c. Start...

Power steering pump — removal and installation
Removal 1. Disconnect the battery from ground. 2. Drain the power steering fluid from the reservoir. 3. Loosen the pump bolts and remove the belt. 4. Squeeze the hose clamp onto the pump fitting, slide the clamp up the...

Removal air from the hydraulic drive circuit
1. Fill the reservoir to the upper mark with Genuine Honda Power Steering Fluid -V (or S). 2. With the engine idling, turn the steering wheel several times in both directions until it stops, then fill the steering gear...

Tightening torques for threaded connections
Tightening torques for threaded connections (Nm) Steering wheel CR-V and 2.2L/2.3L Odyssey 39 3.5L V-6 Odyssey 49 Airbag mounts 9,8 Inner steering rods CR-V 54 2.2L/2.3L Odyssey 78 3.5L V-6 Odyssey 83 Outer tie rod ends...

Possible steering malfunctions
Possible malfunctions and troubleshooting methods Additional checks for microprocessor-based steering

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code