Replacing the speed sensors of the leading and driven pulleys and speed sensors (Honda Civic 7)

1. Disconnect the sensor connector.

2. Loosen the bolt and remove the sensor.

1 - speed sensor No.1, 2 - locking washer (sedan (D17A), hatchback), 3 - locking washer (sedan (D15B)), 4 - speed sensor No.2, 5 - ring seal, 6 - driven pulley speed sensor, 7 - ring seal, 8 - input shaft speed sensor.

3. Remove the O-ring from the sensor.

Note: Installation is carried out in the reverse order of removal.

[The article is based on information from the website: hondabook.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 7: Variator (CVT)

Next ▶

Selector position sensor
Checking the electromagnetic valves
Calibration of the starting clutch
Filter replacement
Road test

Selector S position sensor (hatchback) and selector lock solenoid valve
Selector lever position sensor «P» (hatchback produced since 9/2003)
Manual switching mode switch
Step-up and step-down switches
Control unit

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Civic 8 (2005-2011)

Civic 7 (2000-2005)