Speed sensors for the leading pulley, driven pulley and secondary shaft (Honda HR-V 1)

Replacement

Caution: When replacing the speed sensor, do not allow dust or other foreign objects to enter the gearbox.

1. Disconnect the connector from the drive pulley, driven pulley or secondary shaft speed sensor.

2. Remove the 6mm bolt from the transmission housing and remove the drive pulley, driven pulley or secondary shaft speed sensor.

3. Before installing the drive pulley, driven pulley or secondary shaft speed sensor, replace the O-ring with a new one.

1. SECONDARY SHAFT SPEED SENSOR
2. 6.0x1.0 mm, 12 Nm (1.2 kgf/m)
3. DRIVE PULLEY SPEED SENSOR
4. O-RING, Replace
5. DRIVE PULLEY SPEED SENSOR
6. 6.0x1.0 mm, 12 Nm (1.2 kgf/m)
7. O-RING, Replace
8. O-RING, Replace

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Automatic gearbox

Next ▶

Linear control solenoids and locking solenoid
Table of fault codes
Troubleshooting procedures
Voltage at the contacts of the PCM module — measurement conditions
Electrical diagram of the RCM module (automatic transmission control system)

Starter clutch control
Automatic transmission selector switch
Automatic transmission range indicator
Locking system (models KQ and KU)
Table of automatic transmission faults